3V0-42.20 무료 덤프문제 온라인 액세스

An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.
This information was gathered by the architect during the Discover Task of the Engagement Lifecycle:
Existing hardware will be used in any design proposal.
Network bandwidth cannot be expanded.
Which concept of the Discover Task do these items belong to? (Choose the best answer.)

• A.assumption
• B.constraint
• C.risk
• D.requirement

Which three assessment findings are part of a Conceptual Design? (Choose three.)

• A.assumptions
• B.risks
• C.vendor model
• D.justifications
• E.host names
• F.constraints

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:
Some workloads should be moved to a Cloud Provider.
Extend network's VLAN or VNI across sites on the same broadcast domain.
Enable VM mobility use cases such as migration and disaster recovery without IP address changes.
Support 1500 byte MTU between sites.
Which selection should the architect include in their design? (Choose the best answer.)

• A.Load Balancer
• B.L2 VPN
• C.SSL VPN
• D.Reflexive NAT

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:
The company will use a Leaf and Spine physical network architecture with Layer 3 gateways for top of rack switches.
The company is planning to deploy 120 ESX hosts across 10 racks.
There will be a total of a 12 clusters where each cluster has one host per rack.
What should the architect recommend to allow applications to run on any host in the cluster? (Choose the best answer.)

• A.Deploy a Tier-1 gateway per Rack and configure BGP between racks.
• B.Deploy all application networks on NSX segments.
• C.Deploy an L2 VPN to allow the networks to extend to each host.
• D.Deploy a Tier-0 gateway per Rack and configure BGP between racks.

Which selection must be taken into consideration when creating a Logical Design for a planned migration? (Choose the best answer.)

• A.An N-VDS can only attach to a single VLAN transport zone.
• B.An N-VDS can only attach to a single Overlay transport zone.
• C.An N-VDS can attach to both an Overlay and a VLAN transport zone to a N-VDS having different name/s.
• D.An N-VDS must be disabled before attaching both Overlay and VLAN transport zones.