3V0-41.19 무료 덤프문제 온라인 액세스

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the assessment:
* There must be a performance based SLA for East - West traffic.
Which two key performance features should the architect recommend? (Choose two.)

• A.Install advanced Edge pNIC Features.
• B.Configure N-VDS Enhanced Data Path.
• C.Enable GENEVE-Offload.
• D.Setup RSS to leverage multiple cores.
• E.Leverage DPDK drivers.

Which two resources can be used by an NSX architect during the Assessment Phase? (Choose two.)

• A.VMware customer references
• B.VMware Validated Design
• C.key stakeholder interviews
• D.application licensing
• E.vRealize Network Insight

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:
* Maximum performance and availability is required between the physical and virtual network.
*Load Balancing service is required for back-end web servers.
* NAT is required.
Which should the architect include in their design?

• A.Deploy an Active/Active Tier-0 gateway and configure ECMP.
• B.Create two separate VLANs to connect the Tier-0 gateway upstream traffic and configure ECMP.
• C.Deploy an Active/Passive Tier-0 gateway and configure ECMP.
• D.Deploy a Tler-1 gateway and connect It to an Active/Active Tier-0 gateway with ECMP configured.

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.
During discussions about Centralized Services NAT running on Tier-1 or Tier-0 LR the customer made these requests:
* Services contain stateful services.
* Services should be in high availability mode.
Which two should the architect include in their design? (Choose two.)

• A.The high availability mode supported is only Active-Stand by.
• B.Use only DNAT rules in stateful NAT.
• C.NAT should be applied on the uplink Interface.
• D.An active/active model should be used.
• E.Mix stateful and stateless NAT rules on the same LR.

Which type of design includes vendor models, host names, IP Addresses, port connections, logical unit number sizes, and number of CPUs?

• A.Physical Design
• B.High-Level Design
• C.Logical Design
• D.Conceptual Design