S10-300 무료 덤프문제 온라인 액세스

You notice, from continually monitoring a SAN arry, that an array has a number of soft SCSI bus error. You trace the errors back to a single drive using a vendor's event tool. Which two would correct this? (Choose two)

• A.You should pull the drive out immediately and replace it to prevent data corruption on the RAID set.
• B.Soft SCSI bus errors can be safely ignored as they do not actually denote any service requirements.
• C.Review the logs from the array to identify if there is a pattern of large numbers of these SCSI errors. A large number of these SCSI bus errors may denote a predictive failure.
• D.You should research the error to determine the impact and proper response including the vendor in these discussions

Which statement is correct?

• A.Fan-out is the ratio of storage ports to host ports; an indication of storage load at a single host port.
• B.Fan-out is the ratio of switch ports to host ports; and indication of switch load at a single host port.
• C.Fan-out is the ratio of host ports to storage ports; an indication of host traffic load at a single storage port.
• D.Fan-out is the ratio of switch ports to storage ports; an indication of switch load at a single storage port.

A host is using only 10 percent of a 64 GB volume. Which solution would enable you to reclaim The wasted disk space?

• A.Create a new 16 GB volume use a file system copy to migrate thedatA.
• B.Shrink the 64 GB volume to 16 GB
• C.Create a new 16 GB volume attach the new volume to the production volume as a split mirror snapshot to migrate thedatA.
• D.Create a new 16 GB volume create a COW snapshot of the production volume restore the snapshot to the new volume.

You are tasked with connecting a new pair of hosts to an existing SAN infrastructure. The existing infrastructure is a 2Gb/s Fibre Channel solution on the far side of your facility. What are three concerns for the new infrastructure? (Choose three.)

• A.Re-use of existing Gigabit Ethernet cable infrastructure since Gigabit Ethernet cables have the same specifications and limitations asFibre Channel.
• B.The measured bit error rate (BER) is between "1 in 10^16" and "1 in 10^15"
• C.Patch panels utilizing 50 micron optical cable for the long floor runs and 62.5 micron optical cable for the shorter patch panel to the server.
• D.Cable lengths as long as you measure and insure a proper strength signal as measured in D

A client has four servers they want to attach to a storage array containing 16 ports. Which topology is the most cost effective for this situation?

• A.Switched Fabric
• B.Mesh
• C.Point-to-point
• D.Star