S10-201 무료 덤프문제 온라인 액세스

You are implementing a remote synchronous replication strategy over the FC SAN for disaster recovery. Which two must you consider? (Choose two.)

• A.disk subsystem RAID level compatibility
• B.throughput requirement
• C.ISL aggregation
• D.acceptable latency to the application
• E.location of principal switch

You have recently upgraded a tape drive on a older switch to operate at 120MB/s from 80MB/s. Prior to purchasing the tape drives, you tested server dumps to a disk array across multiple ports and saw speeds exceeding 150MB/s. With the new tape drive, you have not seen any dump speed exceed 100MB/s. What is the most likely cause?

• A.The tape drive has logged in as an iSCSI device.
• B.The new tape drive has logged into the fabric as a storage initiator.
• C.The switch only has 1Gb/s ports.
• D.You have not yet reset the switch port buffer credits.

A customer has a SAS-based storage environment with a SAS domain and some standalone servers, each with multiple built-in SAS disks. The implementation includes direct routing, table routing and subtractive routing. What is table routing?

• A.routing along multiple parallel connections
• B.routing along a physical point-to-point connection
• C.routing between devices connected to an edge expander
• D.routing between devices connected to different edge expanders

Which portion of the 24-bit (aabbcc) fibre channel address identifies the domain ID?

• A.aabb
• B.bbcc
• C.cc
• D.aa

A customer has deployed redundant switched fabrics in a HA environment which also includes non-HA, single-attached test servers. A new project requires additional connectivity for new HA servers to be placed into production, but there are not enough free ports available in one of the existing fabrics to complete the HA deployment. Which option would allow for the addition of the new hosts while maintaining the redundant infrastructure at least cost?

• A.Add ISL's between the existing fabrics to leverage all available ports on the switches.
• B.Cascade the existing switches into a new director class switch and add the hosts to the director.
• C.Add a new switch to both fabrics to increase available ports on the switches.
• D.Add a new switch to the problem fabric to increase available ports on the switches.