E-S4CON-2505 무료 덤프문제 온라인 액세스

You are performing an in place SAP S/4HANA conversion including DMO.
What is the latest point in time when you can reset the procedure without losing business data?

• A.The end of the database migration
• B.The end of the business downtime
• C.The start of the business downtime
• D.The start of the Execution roadmap step

SUM was registered at the SAP Host Agent.
Where does the SAP Host Agent find the path to the SUM directory?

• A.The path is taken from the URL entered in the browser to start SUM.
• B.The path was stored in file sumabap.conf during registration.
• C.The path was stored in file host profile during registration.
• D.The path was stored to the environment of user <sid>adm during registration.

You are using DMO of SUM. You defined 40 parallel R3load processes during uptime and 80 parallel R3load processes during downtime. You have chosen table count verification, but not table contents comparison.
Phase EU_CLONE MIG_DT_RUN is running In the Charts Control Center, you can see 400 process buckets being executed in parallel.
Why are 40 Process Buckets executed in parallel?

• A.There are 40 R3load processes used for copying and 40 R3load processes for table count verification.
• B.SUM is still running in uptime; the 40 defined R3load processes are considered.
• C.Without table contents comparison, only 40 R3load processes are being started.
• D.These are 40 pairs of R3load processes, so there are 80 R3load processes running

You are performing an SAP S/4HANA conversion for your production system. This conversion project requires that certain business functions are switched on. Following SAP recommendations, how will you achieve this? Note: There are 2 correct answers to this question.

• A.Activate the required business functions in the switch framework from section S/4H_ALWAYS_ON_FUNCTIONS.
• B.During conversion, SUM delivers some business functions already activated.
• C.Activate the required business functions manually in the production system.
• D.Import a transport request from the development system that contains the recording of the activation.

How does SUM recognize modification adjustment transports from predecessor systems?

• A.By searching for transport requests named <sid>KO<number>
• B.By searching for transport requests that are assigned to project SAP ADJUST
• C.By searching for transport requests in file umodauto.lst
• D.By searching for transport requests in DIR_TRANS, subdirectory "transport"