C_TSCM42_66 무료 덤프문제 온라인 액세스

In the SAP ECC system, a material is produced using production orders. The planning table for repetitive manufacturing should be used to plan line loading for this material. On the initial screen of the planning table, you select this material and then receive a message informing you that you cannot use the planning table for this material (see attached screenshot).

What could be the reason?

• A.There are no planned orders or production orders present.
• B.There is no valid production version for this material.
• C.The repetitive manufacturing indicator has been set.
• D.There are no requirements present.

What master data do you need for material replenishment using the KANBAN procedure?(Choose two)

• A.Production version
• B.Production supply area
• C.Rate routing
• D.Product cost collector
• E.Control cycle

What can you use to organize material staging for production orders?(Choose three)

• A.Pull list
• B.Transfer orders
• C.Material documents
• D.KANBAN
• E.Logistics Information System (LIS)

Which of the following scheduling types can only be used in capacity planning?

• A.Backward
• B.Only capacity requirements
• C.Midpoint
• D.Forward

The final assembly of a finished product should only be triggered when a customer order arrives.
Which planning strategy for the finished product do you use?

• A.Planning at the assembly level (strategy 70)
• B.Planning with final assembly (strategy 40)
• C.Planning with make-to-stock (strategy 10)
• D.Planning without final assembly (strategy 50)