C-IBP-2202 무료 덤프문제 온라인 액세스

What type of key figure requires a planning level to have all attributes as roots?

• A.The time independent key figure, such as FCSTMAPE
• B.The conversion key figure, such as exchange rate
• C.The attribute transformation key figure, such as PERIODID1
• D.The special key figure marked as an aggregate key figure

You want to restrict value entries outside of a specified range into a key figure. What setting will you use to achieve that goal?

• A.Select Protect Active Worksheet in the About section of SAP IBP tab
• B.IBP -> Lock Selected cells in IBP Formatting Sheet tab
• C.By restricting data input in the Key Figure Configuration app
• D.IBP -> Data Validation in IBP Formatting Sheet tab

Which of the following conditions are relevant for subtotals in the planning view? Note: There are 2 correct Answers to this question.

• A.The total number of attributes that can use subtotals in the planning view can be restricted.
• B.The total value can be added before or after the selected attribute.
• C.Only attribute-based totals can be added to the planning view.
• D.The values of the attribute-based total at the highest attribute level in the planning level can be changed.

You are evaluating criteria for choosing the solver to support planning for a complex supply chain. What are some of the points that should be reviewed? Note: There are 2 correct Answers to this question.

• A.Planning results can be generated faster by the optimizer.
• B.Prioritization of demand elements one by one is achieved by heuristics.
• C.Finite heuristics can achieve demand prioritization and pegging.
• D.Push and Pull production models are used by the optimizer.

You are working to realign the data due to a recent warehouse closure. What should you be aware of in regards to configuration of realignment steps? Note: There are 2 correct Answers to this question.

• A.The number of steps in realignment run is limited to 255.
• B.If a realignment step fails, subsequent steps are not processed.
• C.The realignment step status must be set to In Review for it to be executed.
• D.The name of the realignment step should be no longer than 20 characters.