1Z0-1002 무료 덤프문제 온라인 액세스

Your customer has the following business requirement. There are two work definitions created in the application. One Work Definition for Engine Finished Good and other Work Definition for Pallet Finished Good. The Engine Finished Good item should have Pallet Finished Goods as one of its component.
Identify the way to establish the relationship between Pallet and Engine Work Definitions.

• A.Create a Subinventory that could be the completion Subinventory for yielding the pallet and then the same Subinventory can serve as the supply Subinventory of the pallet in the Work Definition created for Engine.
• B.Assign a higher priority to the Work Definition created for Engine and a lower one for the Work Definition for Pallet.
• C.The two Work Definitions can be tied through Project or Seiban numbers.
• D.The Work Definition versions can be used to tie the Work Orders.

A customer has a distribution warehouse (DW) for After Sales and Service and an in-house manufacturing plant (MP). Sales orders are created and shipped from DW.
Identify the two Sourcing Rules that need to be set for order promising to schedule the order.

• A.Define Local sourcing rule for organization DW: Source Type Make From, Source MP
• B.Define Local sourcing rule for organization MP: Source Type Transfer To, Source DW
• C.Define Local sourcing rule for organization DW: Source Type Transfer From, Source MP
• D.Define Local sourcing rule for organization MP: Source Type Make At, Source MP

A Work Center created a month ago is no longer in use now. You want to remove the Work Center; however, the system is no allowing you to delete it.
Identify three reasons for this.

• A.The Work Center is being referenced in the Closed Work Order.
• B.There are resources associated with the Work Center.
• C.The work center is being references in the work definition operation.
• D.The work center is being referenced in the Work Area.
• E.The Work Center is being referenced in the Open Work Order.

In what three ways can you set the overcompletion tolerance for a subcomponent yield, so the job order can report the excess production completion?

• A.Overcompletion Tolerance Type = Percentage, value > 0
• B.Overcompletion Tolerance Type = Amount, value = 0
• C.Overcompletion Tolerance Type = Percentage, value = 0
• D.Overcompletion Tolerance Type = Amount, value > 0
• E.Overcompletion Tolerance Type = Percentage, value = 100

While creating an item in Product Information Management (PIM), the following two item templates are selected in sequence and applied.
1. Template: Finished Goods (WIP = No, Customer Ordered = Yes)
2. Template: Sub-assembly (WIP = Yes, Customer Ordered = No)
Identify the Item Attribute values in the application.

• A.WIP = Yes, Customer Ordered = No
• B.WIP = Yes, Customer Ordered = Yes
• C.WIP = No, Customer Ordered = No
• D.WIP = No, Customer Ordered = Yes