NCP-BC 무료 덤프문제 온라인 액세스

What snapshot recovery point interval does Self-Service Restore support in a Nearsync setup?

• A.30 minutes
• B.15 minutes
• C.4 hours
• D.1 hour

After a storage failover in a synchronous replication environment, users report higher I/O latency and degraded performance compared to pre-failover levels. Cluster health is normal, and replication is functioning correctly.
Which post-failover cleanup action could the administrator perform to correct the performance issue?

• A.Manually realign the compute and storage locations of the affected VMs.
• B.Increase the snapshot retention period of the affected VMs.
• C.Wait for Acropolis Dynamic Scheduler to rebalance the workloads of the affected VMs.
• D.Reconfigure the replication schedule of the affected VMs.

An administrator intends to configure a NearSync replication schedule with a 15-minute Recovery Point Objective (RPO) on a hybrid 3-node cluster. The current nodes in the cluster are configured with one SSD and four HDDs each.
Which cost-effective modification is required to support this specific replication schedule?

• A.Add a second SSD to each node to meet the minimum requirement.
• B.Configure the cluster with a minimum of four nodes.
• C.Increase the Controller VM (CVM) memory to 64 GB.
• D.Replace the HDDs with NVMe drives to support the IOPS requirement.

An administrator builds a single recovery plan that includes workloads protected with Asynchronous (async) and Nearsync replication schedules together with workloads protected by Synchronous replication (syncrep) schedules, to keep failover seamless during an outage.
Which statement is true regarding this configuration?

• A.Mixing async and nearsync in the same recovery plan is supported.
• B.Mixing schedule types in the recovery plan only affects retention, not recovery success.
• C.Mixing async and syncrep schedules in one recovery plan is supported.
• D.Mixing is supported only for test failovers, but not for planned or unplanned failovers.

Recently, several new VMs were deployed as part of an application expansion. Within 24 hours, the administrator notices no recovery points are being created for the new VMs.
During investigation, the administrator observes:
Existing VMs in the Protection Policy continue to replicate successfully.
No replication task failures are reported.
Network connectivity between clusters is healthy.
Storage capacity at the remote site is sufficient.
The Protection Policy uses category-based entity selection.
The newly deployed VMs were provisioned by a separate team.
What is the most likely root cause of the issue?

• A.Snapshot retention settings are too low.
• B.The replication schedule must be changed to Nearsync.
• C.The recovery plan must be recreated.
• D.The new VMs were not added to the required category.