NS0-183 무료 덤프문제 온라인 액세스

You are installing a new ONTAP 9.7 cluster by following the installation and setup poster. You are ready to complete the initial cluster setup. You have connected your laptop to the management switch. However, when browsing the network, you are unable to discover the ONTAP controllers.
Which statement explains this behavior?

• A.You do not have a static IP address.
• B.You do not have IPv6 configuration set.
• C.You do not have a default gateway set.
• D.You do not have network discovery enabled.

What are two ONTAP storage efficiency technologies that would be used on an AFF A400 cluster? (Choose two.)

• A.thin provisioning
• B.FlexClone volumes
• C.Flash Pool
• D.FlashCache

When you install a new ONTAP 9.7 4-node cluster, which network type is required?

• A.peering network
• B.cluster interconnect
• C.data network
• D.intercluster network

You are adding new controllers to an existing cluster. As part of the upgrade process, you have updated the BES-53248 cluster switches.
In this scenario. Which two commands would you use to verify a healthy cluster after the upgrade? (Choose two.)

• A.network port show -ipspace Cluster
• B.network device-discovery show -protocol cdp
• C.network interface show -vserver Cluster
• D.network interface show -vserver Cluster -fields auto-revert

In an ONTAP switched cluster, which three types of traffic travels over the cluster network? (Choose three.)

• A.Epsilon voting
• B.remote cluster peering
• C.intercluster SnapMirror
• D.cluster database replication
• E.intracluster SnapMirror