070-413 무료 덤프문제 온라인 액세스

Your network contains an Active Directory forest that has two domains named contoso.com and europe.contoso.com. The forest contains five servers. The servers are configured as shown in the following table.

You plan to manage the DHCP settings and the DNS settings centrally by using IP Address Management (IPAM).
You need to ensure that you can use IPAM to manage the DHCP and DNS settings in both domains. The solution must use the minimum amount of administrative effort.
What should you do?

• A.Upgrade DC1 and DC2 to Windows Server 2012, and then install the IP Address Management (IPAM) Server feature. Run the Set-IpamConfiguration cmdlet for each domain.
• B.Upgrade DCE1 and DCE2 to Windows Server 2012, and then install the IP Address Management (IPAM) Server feature. Run the Set-IpamConfiguration cmdlet for each domain.
• C.Upgrade DCE1 and DCE2 to Windows Server 2012, and then install the IP Address Management (IPAM) Server feature. Run the Invoke-IpamGpoProvisioning cmdlet for each domain.
• D.Upgrade DC1 and DC2 to Windows Server 2012, and then install the IP Address Management (IPAM) Server feature. Run the Invoke-IpamGpoProvisioning cmdlet for each domain.

Your network contains a server named Server1 that runs Windows Server 2012. Server1 has the Network Policy Server server role installed.
You configure Server1 as part of a Network Access Protection (NAP) solution that uses the 802.lx enforcement method, You add a new switch to the network and you configure the switch to use 802.lx authentication.
You need to ensure that only compliant client computers can access network resources through the new switch.
What should you do on Server1?

• A.Add the IP address of each new switch to the list of RADIUS clients.
• B.Add the IP address of each new switch to a connection request policy as an Access Client IPv4 Address.
• C.Add the IP address of each new switch to a remediation server group.
• D.Add the IP address of each new switch to a remote RADIUS server group.

Your network contains an Active Directory domain named contoso.com. The Active Directory site topology is configured as shown in the exhibit. (Click the Exhibit button.)

DC1 and DC2 run Windows Server 2003 R2. All FSMO roles are located on DC2.
You plan to deploy a read-only domain controller (RODC) to Site3.
You need to recommend changes to the network to support the planned RODC implementation.
What should you recommend?
More than one answer choice may achieve the goal. Select the BEST answer.

• A.Replace DC1 with a domain controller that runs Windows Server 2012.
• B.To Site2, add an RODC that runs Windows Server 2012.
• C.Replace DC2 with a domain controller that runs Windows Server 2012.
• D.To Site1, add an RODC that runs Windows Server 2012.

You need to give Great Britain division access to the UKSales application What should you set up?

• A.a multi tenant Remote Access VPN gateway
• B.a multi-tenant client-to-site VPN gateway
• C.a web application proxy
• D.a border Gateway protocol

HOT SPOT
You need to recommend a high availability solution for the virtual machines hosted in HostGroup1. The solution must meet the technical requirements.
Which storage layout and provisioning type should you include in the recommendation? To answer, select the appropriate storage layout and provisioning type in the answer area.
NOTE: Each correct selection is worth one point.

정답:

We need to use the Mirror (3-way mirror) layout to meet this requirement in Windows Server 2012.
Windows Server 2012 R2 added the dual-parity option which would allow for two failed disks. However, in Windows Server 2012, single-parity is the only option available and that can only tolerate a single disk failure.
Clustered Hyper-V hosts only support Fixed disks.