070-412 무료 덤프문제 온라인 액세스
| 시험코드: | 070-412 |
| 시험이름: | Configuring Advanced Windows Server 2012 Services |
| 인증사: | Microsoft |
| 무료 덤프 문항수: | 455 |
| 업로드 날짜: | 2025-09-05 |
Your network contains an Active Directory domain named contoso.com.
The domain contains a domain controller named Dc1. DC1 has the DNS Server server role installed.
The network has two sites named Site1 and Site2. Site1 uses 10.10.0.0/16 IP addresses and Site2 uses
10.11.0.0/16 IP addresses.
All computers use DC1 as their DNS server. The domain contains four servers named Server1, Server2, Server3, and Server4.
All of the servers run a service named Service1. DNS host records are configured as shown in the exhibit.
(Click the Exhibit button.)
You discover that computers from the 10.10.1.0/24 network always resolve Service1 to the [P address of Server1.
You need to configure DNS on DC1 to distribute computers in Site1 between Server1 and Server2 when the computers attempt to resolve Service1.
What should run on DC1?
Your network contains an Active Directory domain named contoso.com.
The domain contains a main office and a branch office. An Active Directory site exists for each office.
All domain controllers run Windows Server 2012 R2. The domain contains two domain controllers.
The domain controllers are configured as shown in the following table.
DC1 hosts an Active Directory-integrated zone for contoso.com.
You add the DNS Server server role to DC2.
You discover that the contoso.com DNS zone fails to replicate to DC2.
You verify that the domain, schema, and configuration naming contexts replicate from DC1 to DC2.
You need to ensure that DC2 replicates the contoso.com zone by using Active Directory replication.
Which tool should you use?
You have a server named Server1 that runs Windows Server 2012 R2.
You modify the properties of a system driver and you restart Server1.
You discover that Server1 continuously restarts without starting Windows Server 2012 R2.
You need to start Windows Server 2012 R2 on Server1 in the least amount of time. The solution must minimize the amount of data loss.
Which Advanced Boot Option should you select?
You have a server named Server1 that runs Windows Server 2012 R2.
Each day, Server1 is backed up fully to an external disk.
On Server1, the disk that contains the operating system fails.
You replace the failed disk.
You need to perform a bare-metal recovery of Server1 by using the Windows Recovery Environment (Windows RE).
What should you use?
Your network contains an Active Directory domain named contoso.com.
The domain contains two domain controllers named DC1 and DC2 that run Windows Server 2012 R2.
DC1 and DC2 fail to replicate Active Directory information.
You confirm that DC1 and DC2 have network connectivity.
The NTDS Settings of DC2 are configured as shown in the NTDS Settings exhibit. (Click tie Exhibit button.)
DNS is configured as shown in the DNS exhibit. (Click the Exhibit button.)
You need to ensure that DC1 and DC2 can replicate immediately.
Which two actions should you perform? (Each correct answer presents part of the solution. Choose two.)