JN0-692 무료 덤프문제 온라인 액세스

You have committed a configuration on router R1 as shown in the exhibit. However, it resulted in a (*, G) join for only one group (228.1.1.1) on R1.
Which additional configuration would result in the creation of a (*, G) join for the other group (232.1.1.1)?

• A.Enable PIM version 1 on interface xe-5/2/0.0.
• B.Configure another RP for the other group
• C.Add relevant configurations for an SSM map.
• D.Enable PIM on all interfaces.
  Juniper JN0-692 Exam

Your network is configured with a full mesh of MPLS LSPs between all devices. However, when you enter the show route table inet.2 command on any device, no LSP routing information is displayed.
Which statement explains why this is occurring?

• A.Advanced super-user permissions are required to access the inet.2 table.
• B.IGP routes have a better route preference, causing the LSPs to be hidden.
• C.The inet.2 table does not contain LSP routing information.
• D.A filter is applied that is preventing the LSPs from being installed in the inet.2 table.

You have applied a customized EXP rewrite rule on router R1 on the egress of the interface connecting to router R2. You want to verify if it is working properly. Which two methods would you use to accomplish this task? (Choose two.)

• A.Use the traceroute utility.
• B.Use an output filter on R1 that matches and counts on various EXP values on packets going to R2.
• C.Use an input firewall filter on R2 that matches and counts on various EXP values on packets coming from R1.
• D.Apply a rewrite rule on the ingress of R2 for packets coming in from R1 and count those packets for the new EXP values with a firewall filter as they leave R2.

You have configured an IS-IS adjacency between routers R1 and R2. However, the adjacency is not coming up. Referring to the exhibit, what appears to be the problem?

• A.The ge-1/1/2.0 interface has IS-IS level 2 disabled.
• B.The ge-1/1/2.0 interface does not have family iso configured.
• C.The R2 interface is down.
• D.The ge-1/1/2.0 interface has IS-IS level 1 disabled.

You have recently added LDP-signaled VPLS to your network. The VPLS connections are established and you have been asked to verify that the forwarding plane is working properly. Which three commands would you use? (Choose three.)

• A.traceroute mpls Idp <fec>
• B.ping mpls Idp <fec>
• C.show vpls mac-table
• D.show vpls connections
• E.show Idp statistics