JN0-347 무료 덤프문제 온라인 액세스

You have deployed a Juniper EX Series switch in the network. The switch receives a broadcast frame on an interface.
Which statement describes the behavior of the switch?

• A.The frame is re-transmitted as a multicast frame on all ports on the switch.
• B.The frame is flooded out all ports that are part of the same VLAN as the receiving port, except for the port on which the frame was received.
• C.The frame is flooded out all ports that are part of the same VLAN as the receiving port, including the port on which the frame was received.
• D.The frame is flooded out all ports in all VLANs configured on the switch.

Which two statements describe aggregate routes? (Choose two.)

• A.The route receives the next hop of the primary contributing route.
• B.Internal routing instabilities can be hidden from external peers
• C.Groups of routes are combined into a single route entry.
• D.Invalid routing prefixes are not advertised to external peers.

What are three components that populate the Ethernet switching table? (Choose three.)

• A.the MAC address of the source node
• B.the time the address was learned
• C.the MAC address of the destination node
• D.the link state
• E.the interface on which the traffic was received

There is a GRE tunnel configured over the Internet between Router-1 and Router-2. An OSPF adjacency is configured over this GRE tunnel. However, the OSPF adjacency briefly reaches the Full state before it is torn down. This cycle repeats indefinitely.
Which two actions would you perform to solve this problem? (Choose two.)

• A.Configure OSPF to not export the tunnel endpoint interface routes.
• B.Configure static routes to the tunnel endpoints.
• C.Configure the physical WAN interfaces on both routers as passive OSPF interfaces.
• D.Configure the GRE interfaces on both routers as passive interfaces in OSPF.

Click to the exhibit button. Referring to the exhibit, which configuration change is needed for an IS-IS Level 1 adjacency between R1 and R2?

• A.Configure the Io0 family ISO address 49.0002.0010.0042.0002.00 on R2.
• B.Disable Level 2 on R2'sge-0/0/1 interface.
• C.Configure the Io0 family ISO address 49.0002.0010.0042.0002.00 on R1.
• D.Enable Level 2 on R1's ge-0/0/1 interface.