JN0-343 무료 덤프문제 온라인 액세스

In the configuration shown in the exhibit, you want to form an EBGP peering relationship to the loopback address of a router administered by your ISP, but the session will not establish. What is causing the problem?

• A.EBGP cannot peer to a virtual address.
• B.The EBGP session needs to be explicitly configured with multihop.
• C.The EBGP session needs to be explicitly configured as type external.
• D.The autonomous system information needs to be configured under [protocols bgp].

Your network design currently consists of a single OSPF backbone area. You are asked to reduce the size of the OSPF link-state database.
Which two steps allow you to accomplish this task? (Choose two.)

• A.Include route summarization on the ABRs participating in the configured areas.
• B.Define multiple backbone areas and interconnect them using virtual links.
• C.Include LSA export summarization policies on all participating ASBRs.
• D.Define multiple nonbackbone areas and connect them to the backbone area.

You must verify whether the prefix 172.28.102.0/24 has been advertised by BGP peer
172.18.1.1 and accepted into the routing table.
Which command would you use to accomplish this task?

• A.show route advertising-protocol bgp 172.18.1.1
• B.show route receive-protocol bgp 172.18.1.1
• C.show route summary
• D.show route protocol bgp 172.28.102.0/24

You just installed Switch-1 and Switch-2 in your network. Both switches are EX Series switches and are connected to each other using a Layer 2 switch port. Switch-1 must run STP, whereas Switch-2 must run RSTP. Given the scenario, which statement is true?

• A.The two switches will not communicate using STP or RSTP.
• B.The two switches communicate using RSTP.
• C.The two switches communicate using STP.
• D.The two switches run in dual-mode and communicate using STP and RSTP.

What is the default next-hop behavior for aggregate routes?

• A.resolve
• B.direct
• C.reject
• D.discard