JN0-333 무료 덤프문제 온라인 액세스

You are asked to change when your SRX high availability failover occurs. One network interface is considered more important than others in the high availability configuration. You want to prioritize failover based on the state of that interface.
Which configuration would accomplish this task?

• A.Create a separate redundancy group to isolate the important interface; set the priority of the new redundancy group to 255.
• B.Configure interface monitor inside the redundancy group that contains the important physical interface; adjust the weight associated with the monitored interface to 255.
• C.Configure IP monitoring of the important interface's IP address and adjust the heartbeat interval and heartbeat threshold to the shortest settings.
• D.Create a VRRP group configuration that lists the reth's IP address as the VIP while using each physical interface that make up the reth definition of each SRX HA pair.

Click the Exhibit button.

A customer would like to monitor their VPN using dead peer detection.
Referring to the exhibit, for how many minutes was the peer down before the customer was notified?

• A.3
• B.2
• C.4
• D.5

What are three characteristics of session-based forwarding, compared to packet-based forwarding, on an SRX Series device? (Choose three.)

• A.Session-based forwarding performs faster processing of existing session.
• B.Session-based forwarding uses six tuples of information.
• C.Session-based forwarding uses stateless packet processing,
• D.Session-based forwarding uses stateful packet processing.
• E.Session-based forwarding requires less memory.

What are three valid virtual interface types for a vSRX? (Choose three.)

• A.VMXNET 3
• B.fxp0
• C.eth0
• D.virtio
• E.SR-IOV

What is the function of redundancy group 0 in a chassis cluster?

• A.The primary node for redundancy group 0 identifies the first member node in a chassis cluster.
• B.The node on which redundancy group 0 is primary determines which Routing Engine is active in the cluster.
• C.Redundancy group 0 identifies the node controlling the cluster management interface IP addresses.
• D.The primary node for redundancy group 0 determines the interface naming for all chassis cluster nodes.