000-221 무료 덤프문제 온라인 액세스

What additional NIM functionality is gained by installing the optional dsm.core fileset?

• A.NIM can initiate DLPAR operations against an installed LPAR.
• B.NIM can automate a TSM backup before applying APARs or patches
• C.NIM can initiate an automated bos_inst install operation of an LPAR.
• D.NIMcanquerytheWWPNofanuninstalledLPAR.

What is the purpose of using relative path names when creating a tar file?

• A.To enable restored files to be extracted to any user-specified location
• B.To restore to a raw device name on the destination system
• C.To allow the tar file to be used on Linux systems
• D.To ensure files are always extracted to a specific path

An administrator has been asked to consolidate disks on an LPAR. Given the following information, which group of actions will remove unneeded disk?

• A.Export datavg Use rmdevto permanently remove hdisk3 re-import db2vg03
• B.Migrate physical partitions from hdisk2 to hdisk3 Remove hdisk2 from datavg Use rmdevto permanently remove hdisk3
• C.Vary off datavg Use rmdevto permanently remove hdisk3 varyonvg dbvg02
• D.Remove hdi sk3 from datavg Use rmdevto permanently remove hdisk3

The nmon output below illustrates typical load when the hosted application is running at peak times. What can be observed from the output?

• A.Enabling SMT4 would improve performance.
• B.Processor folding is restricting available resources
• C.Entitled CPU allocation is set too high.
• D.Virtual processor allocation is set too low.

The AIX hosts node1 and node2 have Ethernet adapters, both named ent0, configured on the same network. Both are dedicated physical 1GB adapter ports in a Host Ethernet Adapter. Based on this information and the output shown for each node, what is the most likely cause of intermittent failures and slow communication between these adapters?

• A.The Multi-Core Scaling mode is enabled. Multi-Core Scaling is interfering with communications because the processor is too busy.
• B.The jumbo_frarnes setting is 'no' and should be set to 'yes'.
• C.The media speed is set differently on the adapters than the endpoints on the switch.
• D.The Shared Ethernet Adapter does not have enough bandwidth to accommodate the network traffic.