HPE6-A69 무료 덤프문제 온라인 액세스

You have designed a new wired solution for a customer that uses gateways and Dynamic Segmentation Which statements about User-Based Tunneling are true? (Select two)

• A.in UBT, the switch sends user role Information to Aruba Gateway
• B.in UBT, the Aruba Gateway performs user authentication
• C.In UBT, the Aruba Gateway assigns the Primary user role
• D.In U8T, the switch performs user authentication.
• E.UBT is supported only with Aruba Gateway standalone

(Scenarios may contain multiple errors which may or may not impact the solution) Refer to the Exhibit.

An engineer has attempted to configure two pairs of switches m the referenced configuration it Is required to implement Multi-Chassis Link Aggregation for each pair of switches The ports of the Aruba 8325 switches used for Agg01 and Agg02 are populated as follows

The configuration includes:

There is an error message stating "mismatched group speed" What should you add to the configuration to correct the error?

• A."speed 10-full" under interfaces 1/1/12 and 1/1/13
• B."allow-unsupported-transceiver
• C."speed 40-full" under interfaces 1/1/49 and 1/1/50
• D."system Interface-group 1 speed I0g"

After a Proof of Concept where NetEdit was used to troubleshoot the network, the customer agrees that NetEdit meets some of its technical goals.
Which technical goals does NetEdit meet? (Select two.)

• A.Simplify network management
• B.improve the network's scalability
• C.improve reliability of mission-critical applications
• D.Minimize network downtime
• E.improve the network throughput

A customer wants to verify the proposed configuration snippets to create a point-to-point link between Aruba Switch and a third-party switch.

Will this configuration work with static routing?

• A.No. the configuration will not work, because the Aruba Switch does not have a locally reachable IP address from the third-party switch.
• B.No. the configuration will not work because the Aruba Switch does not have the "routing" command on it
• C.yes, the configuration should work fine and has no issues
• D.No, the configuration will not work, because the Aruba Switch has an MTU mismatch which will prevent IP communication.

Refer to the exhibit.

Aruba CX 6300 switch has routes in three different VRFs as per the example above. The user needs to leak routes between VRF Secure and VRF Dev. and also between VRF default and VRF Dev The customer Is not able to establish routing between directly connected networks 10.100.50.0/24 and
10.102.26.0/24 Which statement is true regarding the routing troubleshooting?

• A.Route leaking is supported between non-default VRFs only
• B.Multi-protocol BGP routing needs to be defined for route leaking
• C.Route Distinguisher needs to be set to 1 for default VRF.
• D.Route leaking between default and non-default VRFs is supported with Aruba CX 8400.