HPE6-A45 무료 덤프문제 온라인 액세스

Refer to the exhibit.

Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.
What is a typical issue that could cause this output?

• A.asymmetric routing introduced by a routing configuration error
• B.a hardware issue, such as a broken cable
• C.an issue with queuing, caused by mismatched QoS settings
• D.mismatched IP addresses on the VLAN for the link

A network administrator plans to apply DSCP 46 to all traffic on a port. What is required for this configuration to work?

• A.A DSCP map that sets 46 to a priority value.
• B.A QoS policy selects traffic with DSCP 46.
• C.The port has trust set to default.
• D.The port has trust set to DSCP.

What is a reason to implement port security on an AOS-Switch?

• A.to filter traffic at the edge, based on multiple criteria in the MAC header
• B.to enhance the security of an 802.1X solution
• C.to simplify provisioning for devices such as IP phones or printers
• D.to control management access to the switch CLI based on device, as well as user credentials

A network uses MSTP and has AOS-Switches at the access layer. The company wants edge ports on the access layer switches to meet these criteria:
* They prevent all rogue switches that run STP, RSTP, or MSTP from connecting to the network.
* If a rogue switch connects and is then replaced by a proper endpoint, the port recovers automatically
* without IT staff involvement.
How should the network administrator set up the edge ports to meet these requirements?

• A.Enable BPDU filtering.
• B.Enable both root guard and BPDU protection.
• C.Enable loop protection with a timeout period.
• D.Enable BPDU protection with a timeout period.

OSPF Area 1 has two ABRs. One ABR is configured with this range for Area 1: 10.10.0.0/16. The other ABR is not configured with a range for Area 1.
Which type of issue occurs due to this mismatch?

• A.The ABRs lose adjacency in Area 1 and must route all traffic to each other through Area 0.
• B.The ABRs lose adjacency entirely and cannot route traffic between each other at all.
• C.The ABRs create a discontinuous area and disrupt intra-area routing between devices within Area 1.
• D.The ABR core would send Area 1 traffic destined to the other switch through an access switch.