HPE6-A44 무료 덤프문제 온라인 액세스

An administrator wants to determine if an IPSec session is established. In order to tunnel and protect the GRE
data traffic between a RAP and an Aruba Mobility Controller (MC). Which MC command provides this
information?

• A.show crypto ipsec sa
• B.show rap-wml
• C.show crypto isakmp sa
• D.show tunneled-node

A group of users on the same floor of a campus residence experience connectivity problems continuously
throughout the morning. The administrator suspects that it is a L1 problem with physical interference.
What can the administrator do to find the cause of this problem?

• A.Access a controller's spectrum analysis data from AirWave's dashboards, under Home.
• B.Access a controller's spectrum analysis data directly from AirWave with Quick Links.
• C.Access RAPIDS data from AirWave's dashboards, under Home.
• D.Access RAPIDS data from AirWave's RAPIDS section.

An administrator creates a cluster of four Mobility Controllers (MCs). When the administrator verifies the
cluster operation, the administrator notices that it is operating as an L3-connected cluster.
What should the administrator do to ensure that the cluster operates as an L2-connected cluster? (Choose two.)

• A.Include all IP addresses in the same subnets shared by the Mobility Controllers.
• B.Exclude all VLANs that are not trunked to each Mobility Controller.
• C.Ensure that the controller IP addresses are in the same subnet.
• D.Configure a separate VRRP group for each cluster member.
• E.Verify VLAN configuration on the switch trunks that interconnects the Mobility Controllers.

Which protocol communicates RF neighborhood information to an Aruba Mobility Master (MM) for use by
AirMatch?

• A.PAPI
• B.SNMP
• C.AMON
• D.GRE

An administrator sets up a network scan set in AirWave to scan a subnet to identify devices for a firmware
upgrade. The scan completes and AirWave successfully uses the SNMP credentials to validate SNMP access.
However, SSH access fails and the administrator must manually configure the SSH credentials used for all of
these devices.
What should the administrator have done before running the network scan?

• A.Define a scan credentials set for the devices.
• B.Manually upgrade the firmware of the devices.
• C.Change the default credentials of the devices.
• D.Monitor the devices for needed firmware upgrades.