HPE6-A41 무료 덤프문제 온라인 액세스

A server connects to a port on an ArubaOS switch. The network administrator wants to ensure that the port remains forwarding during MSTP topology changes, and changes in the port status do not cause MSTP topology changes.
Which statement describes how the administrator can accomplish this?

• A.The administrator can accept the default behavior of auto-edge.
• B.The administrator can configure the port as an MSTP master port.
• C.The administrator can manually disable STP on the edge port.
• D.The administrator can lower the port's root path cost to zero.

Refer to the exhibit.

Endpoint A sends broadcast ARP requests.
Where are these requests received?

• A.at EndpointB
• B.at EndpointB and at EndpointC
• C.at EndpointC
• D.at EndpointB, at EndpointC, and at EndpointD

What is true about the community string used for SNMPv1 and SNMPv2c?

• A.The community string is like a password transmitted in cleartext, which provides no data integrity or privacy.
• B.The community string encrypts and hashes the SNMP message, which provides for data integrity and privacy.
• C.The community string encrypts the SNMP message, but does not hash it, which provides for data privacy.
• D.The community string hashes the SNMP message, but does not encrypt it, which provides for data integrity.

A network administrator enters this command on an ArubaOS switch with IP routing enabled:

This is the only IP route to 0.0.0.0/0 on the switch.
What is the effect?

• A.The switch uses this route for all traffic unless the traffic matches a route with a lower administrative distance than 10.
• B.The switch uses this route for all traffic unless the traffic matches a route with a lower cost than 10.
• C.The switch uses this route to route all traffic from 10.1.1.1.
• D.The switch uses this route for all traffic that does not match a specific route in its routing table.

An ArubaOS switch operates at its factory default settings. A network administrator connects the switch to a VLAN with a DHCP server. The switch-to-switch connection carries untagged traffic. The administrator wants to use Telnet log in to the switch CLI.
How should the administrator contact the switch and log in?

• A.Contact the switch at its default IP address 172.16.0.254/24 and log in without entering a password.
• B.Contact the switch at its default IP address 192.168.1.1/24 and log in with the default password admin.
• C.Contact the switch at its DHCP-assigned IP address and log in with the default password aruba.
• D.Contact the switch at its DHCP-assigned IP address and log in without entering a password.