HPE6-A40 무료 덤프문제 온라인 액세스

Refer to the exhibit.

Review the command outputs on the Master Controller6 shown in the Exhibits. All controllers in the cluster are Aruba 7220 controllers.
What is the maximum number of APs that can terminate on Controller6?

• A.1024 APs
• B.2 APs
• C.64 APs
• D.2112 APs

An Aruba 7205 controller functions as a standby master: How many Campus Aps can it control while in standby mode?

• A.512
• B.0
• C.256
• D.128

A network engineer troubleshoots a provisioned RAP backup SSID issue that occurs when a user tries to connect to the Internet from a hotel. The engineer test the connection and sees backup SSID from an AP broadcast. The engineer can connect to it and receives an IP address form the RAP's HDCP pool, but the captive portal of the hotel will not come up. The backup SSID is always there, and the enterprise SSID does not appear.
What is a cause of this?

• A.The RAP is added into the RAP whitelist of the controller.
• B.The hotel blocks UDP port 4500 on the hotel edge firewall
• C.The RAP does not Source-NATs user traffic.
• D.The hotel blocks IKE prtocol on the hotel edge firewall

How is an AP redirected to a local controller after the DNS resolution returns the master controller IP address?

• A.The master controller provides the LMS-IP from the AP Group, and the AP uses the LMS-IP that is set in the AP Provisioning based upon the AP Group.
• B.The AP provides the AP name to the controller from the environment variable, and the master controller returns the AP Group. The AP uses the controller-ip attribute that is set in AP provisioning.
• C.The master controller provides the AP Group to the AP, and the AP uses the LMS-IP from the AP-System profiles configured for the AP Group.
• D.The master controller provides the AP Group based upon the AP name, and the AP uses the AP Group controller-ip attribute.

A network engineer designs a network with these requirements:

Which configuration should the engineer recommend at Branch office-2?

• A.Create VLAN 30, create the VLAN with the name Employee in the master controller, and map VLAN
  30 TO Employee VLAN.
• B.Create VLAN 30, create the VLAN with the name Employee in the master controller deployed at Branch office-2, and map VLAN 30 to Employee VLAN.
• C.Create VLAN 30 in the master controller, and map VLAN 30 to the VAP-Employee profile.
• D.Create VLAN 30, create the VLAN with the name Employee in the local controller deployed at Branch office-2, and map VLAN 30 to Employee VLAN.