HPE0-J50 무료 덤프문제 온라인 액세스

A storage integrator is installing an HPE MSA 2042 into a remote location as a part of warehouse automation solution. The site has no IT staff and warehouse employees will not be granted access to the location where the MSA will be installed. The customer is concerned about the inability to control individual AC power outlets connected to the MSA.
Which HPE power delivery equipment can be added to the solution to address these requirements? (Choose two.)

• A.HPE Standard Series G2 Basic PDU
• B.HPE G2 Metered and Switched PDU
• C.HPE G2 Metered PDU
• D.HPE iPDU

A storage integrator is installing the HPE StoreVirtual Centralized Management Console (CMC) to manage a StoreVirtual VSA cluster.
What is the proper procedure to install the console?

• A.Download the CMC Appliance and deploy to a hypervisor not running StoreVirtual VSA nodes.
• B.Download the StoreVirtual CMC installer and run on the computer with a supported Linux operating system.
• C.Download the StoreVirtual CMC installer and start the installation from primary StoreVirtual VSA node.
• D.Download the CMC Appliance and deploy to hypervisors running StoreVirtual VSA nodes.

A storage integrator is planning an HPE StoreVirtual VSA installation.
Which network-related information may be needed for the implementation?

• A.DHCP reservation for virtual IP address of the StoreVirtual cluster
• B.virtual IP address for the StoreVirtual cluster
• C.flow-control needs to be disabled when using 10Gb NICs
• D.jumbo frames need to be enabled for iSCSI traffic

A customer wants to back up their VMware data stores using consistent snapshots for rapid online recovery.
Which RMC components are required when installing the solution?

• A.RMC virtual host, two HPE 3PAR StoreServ Arrays
• B.HPE 3PAR StoreServ Array, RMC, RMC-V plugin
• C.RMC-V plugin installed on all ESX protected hosts
• D.RMC-V plugin installed on the HPE 3PAR StoreServ Array

The storage integrator is about to add new HPE 3PAR StoreServ 8200 to a customer's existing SAN infrastructure.
What must be taken into account when developing a technical action plan?

• A.level of support
• B.customer change control procedures
• C.action plan audience
• D.environmental requirements