HP2-Z37 무료 덤프문제 온라인 액세스

Refer to the exhibit.

A network administrator is setting up a single Multiple Spanning Tree Protocol (MSTP) region onHPComware switches. Switch-1 should be root for instance 1, and Switch-2 should be the root for instance 2. The administrator has already configured the MSTP region on Switch-1, and the priorities on both switches.
Which region settings should the administrator configure on Switch-2?

• A.Region name = mycompany; revision number = 1; Instance 1 = 21-30; Instance 2 = 1120
• B.Region name = mycompany; revision number = 0; Instance 1 = 21-30; Instance 2 = 1120
• C.Region name = mycompany; revision number = 1; Instance 1 = 11-20; Instance 2 = 2130
• D.Region name = mycompany; revision number = 0; Instance 1 = 11-20; Instance 2 = 2130

Refer to the exhibit.

The exhibit shows the IP routing table for an HP Provision switch. The network administrator then enters these commands:

What is the result of this configuration?

• A.The switch load shares connections across the four static next hops.
• B.The switch only adds the last static route entry to the routing table.
• C.All four routes are added to the routing table, but are never used.
• D.The switch only adds the last two static route entries to the routing table.

HP solutions help to meet the needs of which trend in today's data center networks?

• A.virtualized environments
• B.increasing numbers of Layer 3 hops
• C.scale-up for monolithic applications
• D.separation of network and storage traffic

Refer to the exhibit.

All of the switches in the exhibit are running Multiple Spanning Tree Protocol (MSTP). The ports that connect to another switch are not boundary ports. All switches are configured as follows:
Config name = Region 1
Revision number = 1
Instance 1 =VLANs 10 and 12
Instance 2 = VLANs 11 and 13
Currently, only VLANs 1, 10, 11, 12,and 13 exist on the four switches. A network administrator adds VLAN 15 to Switch_C. How is the topology affected by this change?

• A.No topology changes occur with spanning tree.
• B.Switch_C enters a spanning-tree inconsistent state and blocks all ports.
• C.The ports that connect to other switches on Switch_C become boundary ports.
• D.Link load sharing is no longer in effect on Switch_C.

A network administrator logs into an HP Comware switch and receives user privilege level
0. Which commands can the administrator enter with this privilege level?

• A.all commands
• B.all display commands
• C.all commands except user management commands
• D.limited display commands