HP2-Z34 무료 덤프문제 온라인 액세스

Refer to the exhibit

An administrator is configuring an MPLS VPLS Martini solution on PE-1. The VPLS solution should connect customer A sites 1, 2, and 3 Where should the administrator specify the LDP peers and pseudo wire (PW) label for the PWs?

• A.in a Virtual Switch Instance (VSI) for customer A
• B.in service instances on interfaces Ten2/0/1 and Ten2/0/2
• C.in a service instance on interface G1/0/1
• D.in a global cross-connect group

Refer to the exhibit

An administrator is planning an MPLS solution and wants to make sure that traffic from 10.1.0.0716 to 10.2 0.0/16 takes the best path. The solution is not using Traffic Engineering (TE). How does PE-1 choose between the label advertised for 10.2.0.0/16 by P-4 and by P5?

• A.based on which link has the lower MPLS cost
• B.based on which link has the lower LDP cost
• C.based on which peer is the higher priority LDP peer
• D.based on which peer is the next hop in the best route in the IP routing table

Refer to the exhibit

An administrator wants these switches to establish a TRILL region TRILL is enabled globally and nicknames are set. What must the administrator do so that each TRILL switch (RBridge) finds the best path to all other TRILL switches?

• A.Configure IS-IS on VLAN 1 on all the switches.
• B.Configure DRB priorities on all switch-to-switch links.
• C.Create a Virtual Service Instance (VSI) on each switch and define the other switches as TRILL peers.
• D.Enable TRILL with the correct link-type on each switch-to-switch port

Refer to the exhibits Exhibit 1

This data center topology is being set up to use SPBM. VMs in the same subnet should be able to communicate at Layer 2 and be isolated at Layer 2 from other subnets. VS110010 was created for VLAN 10 as shown in Exhibit 2. The administrator is configuring a service instance for the VLAN 10 traffic on Switch 1 interface Ten1/0/1.
What is the correct encapsulation mode?

• A.default
• B.ta99ed
• C.s-vid10
• D.s-vid101

What is the purpose of the nickname in TRILL switch settings?

• A.Administrators can use the nicknames to identify switches in CLI output.
• B.TRILL RBridges use the nicknames as source and destination addresses in TRILL headers
• C.The nickname identifies the TRILL region and must match on every TRILL RBridge in the region.
• D.The nickname is the first factor for electing a root bridge