HP0-Y43 무료 덤프문제 온라인 액세스

View the exhibit.

The OSPF routing table and OSPF settings on an HP 7500 Series routing switch are shown in the exhibit. Which networks does this switch advertise as summary LSAs in Area 0? (Select two.)

• A.10.4.1.0/24
• B.10.4.128.0/18
• C.10.0.5.0/24
• D.10.4.68.0/24
• E.10.4.0.0/18
• F.10.0.0.0/16

If you use the MAC lockout feature to block a specific MAC address on an HP 3500zl switch, which traffic is dropped?

• A.The switch will drop frames only if the source address is the specified MAC address and port security is also configured on the receiving port.
• B.The switch will drop any Layer 2 traffic that contains the specified MAC address as the source address.
• C.The switch will drop traffic from devices directly connected to the specific port on which MAC lockout is enabled if the destination or source address is the specified MAC address.
• D.The switch will drop routed or switched traffic if the destination is the specified MAC address.

View the exhibit.

An HP 5400 zl switch implements the configuration shown in the exhibit. However, when the network administrator tests the configuration, endpoints in VLAN 10 do not obtain global IPv6 addresses. What might be causing this issue?

• A.The switch is not configured to advertise the correct prefix.
• B.The switch has not been enabled for IPv6 globally.
• C.The switch is not implementing DHCPv6 relay.
• D.The switch is suppressing router advertisement (RA) suppression on the VLN.

Before you enable dynamic IP lockdown on an 5400 zl switch, which feature must be enabled first?

• A.connection-rate filtering
• B.ARP protection
• C.port security with eavesdropping protection
• D.DHCP snooping

Which statement accurately describes how network administrators can apply routed access control lists (RACLs) or VU\N access control lists (VACLs) on an HP 8200 zl switch?

• A.A RACL is applied at the global configuration level to filter all traffic routed on the switch.
• B.A VACL applies to any traffic switched within a VLAN.
• C.A RACL controls all inbound or outbound routed traffic on a particular port.
• D.A VACL applies to traffic routed within a particular VLAN.