HP0-Y37 무료 덤프문제 온라인 액세스

Click the Exhibit button and view a network diagram and two switch configurations.
When interface Serial 4 of Router 2 fails, traffic from Router 1 destined for network 156.152.0.0/16 leaves AS 65001 via the Serial 3 interface of Router 1. The administrator prefers that this traffic leaves AS 65001 through interface Serial 5 of Router 2. Which configuration change will achieve the desired results?

• A.Router-1#route-policy Policy permit node 10 apply preferred-value 500bgp 100 peer 16.0.0.2 route-policy Policy
• B.Router-2#bgp 100 peer 16.0.0.1 next-hop-local
• C.Router-2#route-policy Policy permit node 10 apply preferred-value 500bgp 100 peer
  156.152.5.1 route-policy Policy
• D.Router-2#route-policy Policy permit node 10 apply local-preference 500bgp 100 peer
  156.152.5.1 route-policy Policy

Click the Exhibit button and view a network diagram and two switch configurations.

Network 16.2.0.0 /16 is advertised by Router 1 and Router 2 into BGP. All traffic from AS-65002 destined to 16.2.0.0 /16 enters AS 65001 via the Serial 3 interface of Router 1.

The administrator prefers that this traffic enter AS 65001 via interface Serial 4 of Router 2.Which configuration change is most likely to achieve the desired results?

• A.Router-1#route-policy PolicyB permit node 20 if-match ip-prefix Prefix2 apply cost 6000routepolicy PolicyB permit node 100Router-2#route-policy PolicyB permit node 20 if-match ip-prefix Prefix2 apply cost 7000route-policy PolicyB permit node 100
• B.Router-1#route-policy PolicyA permit node 20 if-match ip-prefix Prefix2 apply cost 6000routepolicy PolicyA permit node 100Router-2#route-policy PolicyA permit node 20 if-match ip-prefix Prefix2 apply cost 7000route-policy PolicyA permit node 100
• C.Router-1#route-policy PolicyB permit node 20 if-match ip-prefix Prefix2 apply cost 3000routepolicy PolicyB permit node 100Router-2#route-policy PolicyB permit node 20 if-match ip-prefix Prefix2 apply cost 2000route-policy PolicyB permit node 100
• D.Router-1#route-policy PolicyA permit node 20 if-match ip-prefix Prefix2 apply cost 3000routepolicy PolicyA permit node 100Router-2#route-policy PolicyA permit node 20 if-match ip-prefix Prefix2 apply cost 2000route-policy PolicyA permit node 100

Click the Exhibit button and view both exhibits.




What happens when the 10 Gigabit Ethernet link 1/0/25 shown in the exhibit is disconnected from the HP A5800 switch IRF Member 5? (Select two.)

• A.No interfaces are placed in MAD shutdown.
• B.Interfaces on IRF Member 3 are placed in MAD shutdown.
• C.Interfaces on IRF Member 5 are placed in MAD shutdown.
• D.Interfaces on IRF Member 4 are placed in MAD shutdown.
• E.The IRF split stack is NOT detected.
• F.Interfaces on IRF Member 2 are placed in MAD shutdown.

Click the Exhibit button.

You are beginning the process of replacing Cisco switches at the distribution layer of your network with HP A-Series switches. Management has requested that network downtime must be kept to an absolute minimum. Your migration plan is to connect the A-Series switches in parallel with the distribution switches, as shown in the exhibit.For the A-Series switches to assume all routing functionality at the distribution layer, which configuration change should you complete first on the Cisco switches?

• A.Migrate Hot Standby Router Protocol (HSRP) to Virtual Router Redundancy Protocol (VRRP)
• B.Migrate Enhanced Interior Gateway Routing Protocol (EIGRP) to Open Shortest Path First (OSPF)
• C.Migrate Rapid Per-VLAN Spanning Tree Plus (Rapid PVST+) to Multiple Spanning Tree Protocol (MSTP)
• D.Migrate VLAN Trunking Protocol (VTP) to GARP VLAN Registration Protocol (GVRP)

Click the Exhibit button.

Which combination of BGP attributes will be chosen as the best path for prefix 21.0.0.0/8?

• A.iBGP, LocPrf 110, PrefVal 0
• B.eBGP, LocPrf 90, PrefVal 100
• C.eBGP, LocPrf 90, PrefVal 0
• D.iBGP, LocPrf 110, PrefVal 100