GB0-341-ENU 무료 덤프문제 온라인 액세스

Which wireless protocol can work in the 2.4Ghz frequency band? (Multiple choice)

• A.802.11a
• B.802.11n
• C.802.11ac
• D.802.11g
• E.802.11b

Enable the user based on the number of load balancing between AP1 and AP2, specific parameters are: the session = 5, GAP = 2. Suppose AP1 is connected to 6 clients, and AP2 is connected to 4 clients. At this time, AP1_____ rejects new client access, AP2______ rejects new client access; when AP1 is connected to 6 clients, and AP2 is connected to 5 clients, at this time AP1_____ rejects new client access, AP2______ rejects new client access;

• A.will; will not; will; will not
• B.will not; will not; will; will not
• C.will; will not; will not; will not
• D.will not; will not; will not; will not

The 802.11 protocol is essentially to provide a link layer access service for wireless clients. If you need to query the IP address of the wireless client, which of the following commands can be used?

• A.port-security enable
• B.DHCP-snooping enable
• C.arp-snooping enable
• D.user-isolation enable

H HC 3C wireless controller can view the detailed information of P AP registration through the command "display wlan ap all verbose". The following output is the detailed information of an AP viewed through this command.
Based on the above information, you can know _________. (Multiple choice)

• A.This AP has been registered and online for 42 minutes and 50 seconds. It can be judged whether this AP has been offline based on the running time of the wireless controller.
• B.There are currently no users on this AP because the Running Clients Count is 0.
• C.Admin State is DOWN, indicating that the AP's radio may be in the disabled state.
• D.The model of this AP is WA2100-AG, the status is RUN (successfully registered), and the IP address is 192.168.0.125
• E.Last Join Address indicates the IP address used when the AP successfully established a link with the AC last time. When the AP is disconnected, you can try to telnet to the AP device through this address.

Which is not correct about the air interface utilization?

• A.The AP line is not connected to the terminal, and the air interface utilization rate is 0