NSE6_SDW_AD-7.6 무료 덤프문제 온라인 액세스

Refer to the exhibit.

The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths. However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths Which three settings must the administrator configure inside each BGP neighbor group so spokes can learn the prefixes of other spokes and their additional paths? (Choose three.)

• A.Set additional-pathto forward
• B.Enable route-reflector-client.
• C.Enable route-reflector-server
• D.Set adv-additional-pathto the number of additional paths to advertise.
• E.Set additional-pathto send

Refer to the exhibit.

The administrator configured two SD-WAN rules to load balance the traffic.
Which interfaces does FortiGate use to steer the traffic from 10.0.1.124 to 10.0.0.254?

• A.port1 or port2
• B.Any interface in the HUB1 or HUB2 zones
• C.HUB2-VPN2
• D.HUB1-VPN2 or HUB2-VPN2

Refer to the exhibit that shows a diagnose output on a FortiGate device.

Based on the output shown in the exhibit, what can you conclude about the device role and how it handles health checks?

• A.The device is a hub and it receives embedded health-check measures for each tunnel from the spoke.
• B.The device is a hub and it receives health-check measures for the tunnels of a spoke.
• C.The device is a spoke and it provides embedded health-check measures for each tunnel to the hub.
• D.The device is a spoke and it receives health-check measures for the tunnels of another spoke.

Refer to the exhibits.



You use FortiManager to configure SD-WAN on three branch devices.
When you install the device settings, FortiManager prompts you with the error "Copy Failed" for the device branch1_fgt. When you click Log, FortiManager displays the message shown in the exhibit.
Based on the exhibits, which statement best describes the root cause of the issue?

• A.You cannot combine metadata variables and installation targets.
• B.The metadata variable definitions are incomplete or incorrect.
• C.Gateways for all members in a zone must be of the same type.
• D.The connection between branch1_fgt and FortiManager failed.

You are tasked with configuring ADVPN 2.0 on an SD-WAN topology already configured for ADVPN. What should you do to implement ADVPN 2.0 in this scenario?

• A.Update the IPsec tunnel configurations on the hub.
• B.Update the SD-WAN configuration on the branches.
• C.Update the IPsec tunnel configuration on the branches.
• D.Delete the existing ADVPN configuration and configure ADVPN 2.0.