NSE5_FMG-7.0 무료 덤프문제 온라인 액세스

Which three settings are the factory default settings on FortiManager? (Choose three.)

• A.Password is fortinet
• B.Username is admin
• C.FortiAnalyzer features are disabled
• D.Reports and Event Monitor panes are enabled
• E.port1 interface IP address is 192.168.1.99/24

Refer to the exhibit.

An administrator is about to add the FortiGate device to FortiManager using the discovery process FortiManager is operating behind a NAT device, and the administrator configured the FortiManager NATed IP address under the FortiManager system administration settings What is the expected result?

• A.During discovery FortiManager sets both tie FortiManager NATed IP address and NAT device IP address on FortiGate
• B.During discovery FortiManager sets the NATed device IP address on FortiGate
• C.During discovery FortiManager uses only the FortiGate serial number to establish the connection
• D.During discovery FortiManager sets trie FortiManager NATed IP address on FortiGate

An administrator would like to create an SD-WAN default static route for a newly created SD-WAN using the FortiManager GUI. Both port1 and port2 are part of the SD-WAN member interfaces.
Which interface must the administrator select in the static route device drop-down list?

• A.port1
• B.virtual-wan-link
• C.port2
• D.auto-discovery

Refer to the exhibit.

Given the configuration shown in the exhibit, how did FortiManager handle the service category named General?

• A.FortiManager ignored the firewall service category General and updated the FortiGate duplicate value in the FortiGate database.
• B.FortiManager ignored the firewall service category general and deleted the duplicate value In Its database
• C.FortiManager ignored the firewall service category General but created a new service category in its database.
• D.FortiManager ignored the firewall service category General and did not update Its database with the value

An administrator run the reload failure command: diagnose test deploymanager reload config
<deviceid> on FortiManager. What does this command do?

• A.It compares and provides differences in configuration on FortiManager with the current running configuration of the specified FortiGate.
• B.It installs the provisioning template configuration on the specified FortiGate.
• C.It downloads the latest configuration from the specified FortiGate and performs a reload operation on the device database.
• D.It installs the latest configuration on the specified FortiGate and update the revision history database.