FCSS_NST_SE-7.6 무료 덤프문제 온라인 액세스

Refer to the exhibit, which shows the output of a debug command.

Which two statements about the output are true? (Choose two.)

• A.One of the neighbors has a router ID of 0.0.0.4.
• B.There are a total of five OSPF routers attached to the vorz4 network segment
• C.The interlace is part of the OSPF backbone area.
• D.In the network connected to port4, two OSPF routers are down.

Which three common FortiGate-to-collector-agent connectivity issues can you identify using the FSSO real- time debug? (Choose three.)

• A.Refused connection. Potential mismatch of TCP port.
• B.Mismatched pre-shared password.
• C.Log is full on the collector agent.
• D.Incompatible collector agent software version.
• E.Inability to reach IP address of the collector agent.

Which two statements are true regarding heartbeat messages sent from an FSSO collector agent to FortiGate?
(Choose two.)

• A.The heartbeat messages can be seen in the collector agent logs.
• B.The heartbeat messages can be seen on FortiGate using the real-lime FSSO debug.
• C.The heartbeat messages must be manually enabled on FortiGate.
• D.The heartbeat messages can be seen using the command diagnose debug authd fsso list.

Refer to the exhibit, which shows the port1 interface configuration on FortiGate and partial session information for ICMP traffic.

What happens to the session information if a routing change occurs that affects this session?

• A.Only the interface and gateway information for dev=7 will be removed.
• B.Sessions involving port7 or port19 will not have their routing information flushed.
• C.The session information will not change unless the current route has been removed from the routing table.
• D.The session will be flagged as dirty but no route lookups will be performed.

Refer to the exhibit, which shows a partial output of the real-time LDAP debug.

What two actions can the administrator take to resolve this issue? (Choose two.)

• A.Ensure the user is a member of at least one AD group to ensure step 4 of the LDAP authentication process is successful.
• B.Ensure the user logs in using 'John Smith' not 'jsmith'.
• C.Ensure the user is providing the correct user credentials.
• D.Ensure the account is active.