E20-375 무료 덤프문제 온라인 액세스

What would cause a volume sweep to occur?

• A.A previously enabled splitter is disabled
• B.A previously disabled splitter is enabled
• C.A new Replication Set is added to an enabled Consistency Group
• D.A Replication Set is removed from a disabled Consistency Group

You are adding an RPA to a cluster using Deployment Manager. What requirement must be satisfied before proceeding?

• A.Zoning and LUN masking must be known to be identical to the existing RPAs in the cluster.
• B.RPA and array iSCSI configuration settings must be known. All other zoning and LUN masking settings will automatically be read from the existing RPA site leader.
• C.RPA and Storage iSCSI configuration settings will automatically be read from the cluster.
• D.RPA iSCSI configuration settings must be known. All other zoning and LUN masking settings will automatically be read from the existing RPA site leader.

If you wanted to use the Roll Image in Background option to access an image, which access mode should you select?

• A.Snap Access
• B.Logged access
• C.Direct Access
• D.Virtual Access

When adding a new vRPA, what is the only storage authentication method that is supported?

• A.CHAP
• B.iSNS
• C.RADIUS
• D.LDAP

A new RecoverPoint system is being installed and the RPAs need to be upgraded to the latest version.
How should this be done?

• A.Upgrade the RPAs to the latest version first; otherwise Deployment Manager will prevent the installation.
• B.Install the new system with Deployment Manager and then log in as boxmgmt and perform the upgrade on one RPA.
• C.Choose the option to upgrade the RPA version from an ISO while installing RecoverPoint using Deployment Manager.
• D.Before doing the install ensure all the RPAs IP addresses reach each other. Connect to RPA1 with boxmgmt and do the upgrade.