DES-5121 무료 덤프문제 온라인 액세스

A network administrator has configured a 4-port port-channel between two Dell EMC Campus networking switches. The physical interfaces show as administratively up and operationally up on both switches. However, the port-channel shows as operationally up on Switch A and operationally down on Switch B.
What is a potential reason for the inconsistent port-channel state?

• A.Switch A is configured to use dynamic port-channels and Switch B is configured to use static port- channels
• B.Switch A is configured using channel-group # mode on and Switch B is configured using channel- group # mode auto
• C.Ports in the port-channel on Switch A are all the same speed but the ports in the port-channel on Switch B are a mix of speeds
• D.N-Series supports a maximum number of physical interfaces that can be included in port-channels on a per-device basis

A user's host with an IP address of 172.16.1.22/24 is attempting to FTP a file from the server with IP address 10.1.1.99; however, they are unable to connect.
Which access-list is preventing this traffic?

• A.# ip access-list ACL4
  # permit ip host 172.16.1.22 host 10.1.1.99
• B.# ip access-list ACL2
  # permit ip 172.16.1.0 0.0.0.255 any
• C.# ip access-list ACL1
  # deny ip any host 10.1.1.99
• D.# ip access-list ACL3
  # deny ip any 172.16.2.0 0.0.0.255

What describes the POE+ capabilities of the Dell EMC N1100P Series?

• A.Supported on any of the first 12 switch ports or all switch ports, whichever is fewer.
  May only be enabled on a maximum of half of the supported ports.
• B.Supported on all of the first half of switch ports or the first 12 switch ports, whichever is fewer.
• C.Supported on all of the first 12 switch ports or all switch ports, whichever is fewer.
• D.Supported on any of the first half of switch ports or the first 12 switch ports, whichever is fewer.
  May only be enabled on a maximum of half of the supported ports.

A Master switch failed in a Dell EMC N-Series three-unit switch stack and the Standby switch assumed the role of Master.
What happens when the failed Master switch rejoins the stack after the new Master has taken over?

• A.Switch joins the stack and resumes as the Master
• B.Switch joins the stack as the Standby
• C.Switch must be manually configured to rejoin the stack
• D.Switch joins the stack as a Member

You are tasked with deploying a single Dell EMC N-Series switch with a 2-port port-channel to uplink to an existing upstream switch. The following reflects the upstream switch configuration:
N4032F#show running-config interface tengigabitethernet 1/0/5
channel-group 1 mode on
N4032F#show running-config interface tengigabitethernet 1/0/6
channel-group 1 mode on
Which type of port-channel should be configured to successfully uplink?

• A.Passive
• B.Active
• C.MLAG
• D.Static