DES-4121 무료 덤프문제 온라인 액세스

A technician needs to update the ORAC license on a PowerEdge R740 server Horn Express to Enterprise The server has the following components:
* 2xCPUs
* 384GBRAM
* 6x1TBdrives
* fxPSU
The server is powered down but connected to active AC The user wants it to stay powered down and not connect to any networks No errors are presently displayed. How can the technician upgrade the license?

• A.Power on the server then connect to the rORAC and upgrade iDRAC license before powering the server down
• B.The license cannot be upgraded because the user will not allow the saver to be powered on
• C.The license cannot be upgraded on a smote PSU system
• D.Connect to the iDRAC GUI and upgrade the iDRAC license while the server is powered down

A technician needs to use the iDRAC GUI to toil back a diagnostics firmware revision on a server that was updated four weeks previously. However, the replaced version cannot be found in the Firmware Rollback section on the iDRAC GUI.
What could be the issue?

• A.Rollback feature was not enabled in iDRAC Settings
• B.Firmware can only be rolled back within a week of being replaced
• C.Diagnostics firmware is not supported in the Rollback feature
• D.Diagnostics firmware revision is part of the Lifecycle Controlled firmware so the Lifecycle Controller must be updated first

A technician wants to move memory from a few older systems. What is the most efficient method to accomplish this task?

• A.Power down all the older servers to physically check the memory
  Move any matching memory to the new server
• B.Back up the server profile on the older server
  Hove the matching memory and import the server profile to the new server
• C.Use iDRAC to view the memory details of the older systems
  Power down the servers to move matching memory to the new server
• D.Power down any of the older servers to move any memory lo the new server Update BIOS to allow mismatched memory

A technician is remotely installing EXI 6.0 on a powerEdge R640 in BIOS boot mode.
The system has dual internal SD cards Alter the OS is installed, the system reboots and shows an error screen with the following message 'No boot device found" What should the technician do lo resolve this issue?

• A.Enable vFlash in iDRAC web GUI
• B.Reseat the SD cards and try to boot lo them again
• C.Set the boot mode from BIOS to UEFI
• D.Change the Hard Disk Drive Sequence

After a disk rebuild operation, a technician needs to configure the system so that the rebuild process happens faster in the future, even at the expense of stowing users down How should the technician perform this task?

• A.Change the System Profile to Performance in the System BIOS Setting
• B.Change the Rebuild Rate in the System BIOS Settings
• C.Change the Rebuild Rate from me iDRAC GUI
• D.Change the System Profile 1o performance in the iDRAC GUI