DEE-1721 무료 덤프문제 온라인 액세스

A storage administrator has several hosts and redundant FC switches that been in production for six months.
All zoning complies with port zoning best practices. A new switch is added t one fabric and immediately all paths on that fault domain drop. The network administrator confirms that the switches are properly cascaded and working, and that no zoning or configuration changes have been made.
In order to correct the issue with the dropped paths, which information should be provided to the administrator?

• A.Port zoning requires that FCoE is enabled for high availability
• B.SCOS must be uploaded to support the new switch
• C.Server mapping must be updated to use the new paths
• D.Domain ID of the switches changed

Based on best practices, which parameter values should be used on a QLogic HBA?

• A.Connection options:1 - point-to-point onlyLogin retry count:30 attemptsPort down retry count:5attemptsLink down timeout:60 seconds
• B.Connection options:0 loop onlyLogin retry count:30 attemptsPort down retry count:30 attemptsLink down timeout:30 seconds
• C.Connection options:1 - point-to-point onlyLogin retry count:60 attemptsPort down retry count:60 attemptsLink down timeout:30 seconds
• D.Connection options:0 - Loop onlyLoginretry count:60 attemptsPort down retry count:60 attemptsLink down timeout:30 seconds

After setting up an SC4020 and turning on the system, both controllers initialize to Safe Mode and are ready for configuration You plug the serial cable into the first controller and type the platform prejoin show command You then receive the command output shown in the exhibit

If you continued configuring the controller, what are the reasons why the deployment will fair?

• A.Serial cable needs to be plugged into the bottom controller Controller chassis is installed upside down in the rack
• B.Serial cable needs to be plugged into the top controller eth1 IPv4 IP address used at the factory to load the firmware was not cleared before shipping
• C.Serial cable needs to be plugged into the top controller Controller chassis is installed upside down in the rack
• D.Serial cable needs to be plugged into the bottom controller eth1 IPv4 IP address used at the factory to load the firmware was not cleared before shipping

You are installing an SC Series system with 48 hard drives running SCOS version 7.x. Half of the disks are
15K RPM and the other half are 10K RPM. You do not have the option to select the storage profile when creating the volumes.
How can this issue be reasolved?

• A.Apply the Enterprise Plus license to the Storage Center
• B.Select "Allow Storage Profile Selection" under "preferences"
• C.Install more than 48 hard drives to meet the SCOS 7.x minimum
• D.Assign 10K drives to default to the low priority tier

A local SC Series storage array is replicating to a remote SC Series storage array. A problem occurs on the local array which causes you to failover to the remote array. Once the issue is controlled, you need to failback to the local array. However, when you attempt to failback to the local array, no volumes are available to failback.
What is the reason for this Issue?

• A.Local SC Series array is still running
• B.Replication restore points need to be validated
• C.No replication QoS definitions exist
• D.Remote SC Series array is still running