DEE-1111 무료 덤프문제 온라인 액세스

A three-brick PowerMax 8000 is running PowerMaxOS 5978.444.444. The system is configured with Flash Drives RAID 5 (7+1). The customer wants to expand the capacity with SCM drives.
Which minimum configuration is supported?

• A.2x RAID 5 (7+1) added to brick one
• B.1x RAID 5 (7+1) added to brick one
• C.1x RAID 5 (7+1) added to each brick
• D.3x RAID 5 (7+1) added to each brick

An SRDF/Metro Smart DR configuration experiences a service interruption.
What criteria will the Fault-Aware Witness give a higher priority to when selecting the winning array?

• A.Bias
• B.Presence of a DR leq
• C.Synced SRDF/A leg
• D.Director status

A storage administrator is investigating non-linear variations in throughput when zoning additional hosts to certain front-end adapters. They notice a certain performance characteristic having 10 identical hosts zoned to the same FA ports. After adding the 11th host, the throughput sometimes drops more than 20%.
What is the most likely cause of this behavior?

• A.I/O sizes over 128 KiB are being used on the hosts
• B.Average disk queue length on the hosts exceed 3
• C.System Write Pending > 75%
• D.QFULL responses of the FA ports

SRDF/Metro has been implemented with the bias setting. The R1 side of the pair is configured as the bias side.
How does the device bias work with the R2 device if the R1 array has a failure?

• A.Device bias is unable to make the R2 device available to the host
• B.R2 device automatically becomes the active device
• C.R2 device automatically becomes the bias device
• D.Device bias performs a half-swap, and the R2 device becomes the new R1 device

Refer to exhibit.

Refer to the exhibit.
Which correctly describes a possible configuration created by SYMACL?

• A.Hosts that are part of AdminGrp proup
• B.Only ADMINRD access type
• C.Physical hosts that are part of EmcMgmtGrp group
• D.Only BASECNTROL access type