D-PE-OE-01 무료 덤프문제 온라인 액세스

Where is the Asset Tag located on the Dell EMC PowerEdge server?

• A.BIOS settings
• B.Pull-out information tab
• C.Server chassis
• D.Dell manufacturing label

A remote technician needs to update the iDRAC with Lifecycle Controller firmware using the iDRAC GUI. They have downloaded the iDRAC firmware to the management station and connected to the iDRAC GUI.
What step is required to complete this task?

• A.Boot the server into F10
• B.Reboot the server to apply the update
• C.Use the Firmware Update page to upload and install the firmware
• D.Start the Lifecycle Controller and select Firmware Update

A technician tries to power on a server but nothing happens when they press the power button. The status LEDs on both PSUs are green. The technician is able to connect to the iDRAC to review the System Event Logs and discovers that PSU2 has failed.

• A.Reboot the server, Test one PSU at a time
• B.Cycle the AC power, Reset the NVRAM
• C.Cycle the AC power, Test one PSU at a time
• D.Reboot the server, Reset the NVRAM

A server administrator needs to configure iDRAC to send email alerts. When the administrator runs a test, the error "Sending the test mail failed" is returned.
The administrator enables platform event filter alerts and configures the following settings:
IP: 172.168.1.10/24
Gateway: 172.16.1.1
DNS: 172.168.1.100
SMTP: 172.168.1.5
Destination email address (enabled): administrator@example com
The administrator has NOT made any other changes to iDRAC.
What should the administrator do to correct the issue?

• A.SMTP authentication must be configured
• B.Verify iDRAC SMTP settings match SMTP server
• C.Change the SMTP server to its FQDN
• D.Update iDRAC to the latest revision

A customer reports four physical GPUs installed but only three are detected by the OS on a PowerEdge XE with NVIDIA cards. Which command should be used to identify the missing GPU?

• A.rocm-smi
• B.dcgmi diag -r 4
• C.nvidia-smi -L