D-PDC-DY-23 무료 덤프문제 온라인 액세스

Which two steps are required when configuring ports to operate in a VLT port channel? (Select 2)

• A.Configure the channel-group member under the physical interface.
• B.Configure the channel-group member under the port channel interface.
• C.Configure the port channel interface as a VLT port channel.
• D.Configure the physical interface as a VLT port channel.

What should be disabled on an interface before disabling LLDP transmit capability?

• A.Loop Guard
• B.STP
• C.LLDP-MED
• D.VLAN 1

Two Dell Networking OS10 switches in a VLT configuration must be upgraded.
How will the reload of these switches proceed to result in the default initial state?

• A.Reload the primary VLT node and wait for it to join as secondary.
  Wait until after delay restore timer has expired.
  Reload VLT secondary node and wait for it to join as secondary.
• B.Reload the primary VLT node.
  This will automatically trigger the simultaneous reload of the secondary node.
• C.Reload the primary VLT node and wait for it to join as primary.
  Wait until after delay restore timer has expired.
  Reload VLT secondary node and wait for it to join as secondary.
• D.Reload the primary VLT node.
  This process will automatically trigger the reload of the secondary node after it has recovered.

In a Layer 3 Leaf-Spine topology what can be used to move Layer 2 traffic between racks?

• A.Trunks
• B.VXLAN
• C.Port channel
• D.VLT

A network administrator wants to configure a timing protocol with these requirements:
- Hardware time stamping to achieve sub microsecond synchronization.
- Master IP address: 192.168.1.100.
- Use interface Ethernet 1/1/1 to enable timing protocol.
Which configuration supports the requirements?

• A.OS10(config-if-eth1/1/1)# ntp authenticate
  OS10(config-if-eth1/1/1)# ntp trusted-key 345
  OS10(config-if-eth1/1/1)# ntp authentication-key 345 md5 0 5A60910FED211F02 OS10(config-if-eth1/1/1)# ntp server 192.168.1.100 key 345 OS10(config-if-eth1/1/1)# ntp master 7
• B.OS10(config)# ntp authenticate
  OS10(config)# ntp trusted-key 345
  OS10(co345 md5 0 5A60910FED211F02
  OS10(config)# ntp server 192.168.1.100 key 345
  OS10(config-if-eth1/1/1)# nfig)# ntp authentication-key ntp master 7
• C.OS10(config)# ptp clock boundary
  OS10(config)# ptp domain 1
  OS10(config)# ptp system time enable
  OS10(config-if-eth1/1/1)# ptp enable
  OS10(config-if-eth1/1/1)# ptp role slave
  OS10(config-if-eth1/1/1)# ptp transport ipv4 unicast slave
  OS10(config-if-eth1/1/1-ptp-ipv4-slave)# master 192.168.1.100
• D.OS10(config)# ptp clock boundary
  OS10(config)# ptp domain 1
  OS10(config)# ptp system time enable
  OS10(config)# ptp enable
  OS10(config)# ptp role master
  OS10(config)# ptp transport ipv4 unicast slave
  OS10(config-if-eth1/1/1)# master 192.168.1.100