DSDSC-200 무료 덤프문제 온라인 액세스

When replacing a defective SC4020 controller with a new controller, the engineer notices that the new controller does NOT fully initialize. The system runs SCOS version 6.5.30.
Which three actions should the engineer take? (Choose three.)

• A.remove the battery from the controller
• B.note the controller LEDsthat are lit or blinking
• C.send a PhoneHome/SupportAssist
• D.contact Dell Support
• E.remove power cables from the chassis to drain the BMC

A customer has a newly installed storage array. The customer needs to proactively monitor and report storage utilization on a regular basis.
Which customizable, proactive tool should be configured to perform this task?

• A.Storage Center Event Monitoring
• B.Enterprise Manager Threshold Alerting
• C.Enterprise Manager Automated Reporting
• D.Dell SupportAssist

What is the first sequence of commands that should be used to initialize an SC8000 system after connecting the serial cable?
A)

B)

C)

D)

E)

• A.Option D
• B.Option B
• C.Option A
• D.Option C

A Storage Administrator wants to do a Storage Center OS update to SCOS version 6.7.5.
The Storage Center is currently at SCOS version 6.5.30.
The Storage Center is at a secure facility and does NOT allow connectivity to any network outside the facility.
The Storage
Administrator is trying to use the Storage Center Update Utility to accomplish this task, but has been unsuccessful in doing so.
Why has the Storage Administrator been unsuccessful?

• A.The Storage Center hasNOTpassed Pre-Upgrade checks and is blocking the update from occurring.
• B.The Storage Center isNOTat the minimum required SCOS version to use the utility.
• C.The Storage Center isNOTlicensed to use the Storage Center Update Utility.
• D.The secure facility is NOTallowing the StorageAdministrator's laptop to connect to the Storage Center across the network.

Which method should be used to map a volume to a server in Enterprise Manager?

• A.In the Storage Viewer: highlight an unmapped volume and click the "Map Volume to
  Server" button on the top button bar.
• B.In the Server Viewer: highlight the server on the list andclick the "Map Volume to Server" button on the top button bar.
• C.In the Reporting Viewer: open the mapping report, click "CreateNew Mapping", and provide the requested information.
• D.In the Storage Viewer: during the Volume Create wizard, click the "Mapping Options" link, and choose the server to map to.