DNDNS-200 무료 덤프문제 온라인 액세스

Refer to the exhibit.
Two S-Series switches are configured as a VLT pair. The output from the first peer switch is as shown.
Which three results can be determined based on the output shown? (Choose three.)

• A.The VLTi peer-link has not been created between the two VLT peers.
• B.The domain ID was automatically created based on the System MA.
• C.VLTs downstream to other devices will not form because the versions are the same for both VLT peers.
• D.The restoration of VLT ports after a system has been rebooted has been manually configured.
• E.The command back-up destination command has been applied but there is no IP- reachability for Backup-Link connectivity between Peers.
• F.The System Mac was statically defined by an administrator, and all downstream switches only see this MAC address.

A network engineer is modifying an existing VLT configuration with two identical S-Series switches. Each VLT peer must be configured to route on behalf of each other for a period of time during peer failure. As part of a larger network, the switches run OSPFv2.
Which set of commands is required to make sure that each peer will proxy-route for 20 seconds?

• A.DellSwitch1(config)#vlt domain
  100DellSwitch1(config-vlt-domain)#peer-proxyDellswitch1(config-vlt-domain)#peer-proxy -route
  20000
• B.DellSwitch1(config)#vlt domain
  100DellSwitch1(config-vlt-domain)#peer-routingDellswitch1(config-vlt-domain)#peer-routing-timeout
  20
• C.DellSwitch1(config)#router ospf 10DellSwitch1(config-ospf-10)#vlt
  routeDellswitch1(config-ospf-10)#vlt timing 20
• D.DellSwitch1(config)#vpc domain
  100DellSwitch1(config-vpc)#peer-gatewayDellswitch1(config-vpc)#peer-gateway-timeout 20

Exhibit 1.

Exhibit 2.

Refer to the exhibits. A network engineer is unable to establish OSPF Neighbor Adjacency between two S-Series switches. Based on the output from the two switches, what is preventing OSPF Neighbor Adjacency?

• A.The Process ID on each switch should not be the same
• B.The two switches are both in the DR state
• C.The IP Address configured on each switch is in the same subnet
• D.There is an issue with the OSPF Timer Intervals

An N-Series stack has been implemented. The network engineer needs to verify that all switches in the stack are running the same firmware.
Which command should be used to verify stack status?

• A.Show run
• B.Show switch
• C.Show stack
• D.Show stack-port all

Refer to the exhibit. Given the output shown, which application IDs make up the default routing instance?

• A.Application IDs 9,10,11,12
• B.Application IDs 18,19,20,21,22
• C.Application IDs 1,2,3,4
• D.Application IDs 13,14,15,16,17