DCPPE-200 무료 덤프문제 온라인 액세스

A VRTX server comes with two server modules. The customer requests to assign three PCIe Adapters per each server module. While performing this configuration, the engineer is unable to assign more than two PCIe Adapters per server module.
What is the cause of this issue?

• A.The VRTX chassis came with a CMC Express License.
• B.The CMC configuration needs to be reset to the factory defaults.
• C.This is a limitation of VRTX chassis.
• D.The VRTX chassis needs to be updated with the latest firmware.

An engineer is deploying a chassis with four IOAs and connecting it to the top of rack (ToR) switch. The deployment mandate requires that the switches can be managed individually. Also, future servers can be added to network with the minimal amount of configuration.
The following steps have been completed:
- Cabled port 9 between the two IOMs
- Cabled ports 10 and 11 on both IOMs to the ToR
- Configured a team on NIC ports 1 and 2 on the server
How should the IOMs be configured?

• A.Full Switch
• B.Programmable MUX
• C.Stack
• D.Virtual Link Trunking

A VRTX has storage set up as a RAID 10 in a 16-drive disk group. Each drive is 1.6 TB for a total of 12.8 TB space in the disk group. There are currently 14 virtual disks of 600GB each. The engineer needs to create three more virtual disks. The engineer successfully creates two virtual disks but is unable to create the third because there are NO physical disks to choose from.
What must the engineer do to create the final virtual disk?

• A.Update the Shared PERC 8 Firmware
• B.Recreate the virtual disks with 400GB allocated
• C.Create a new disk group with additional physical disks
• D.Perform a reconstruct of the physical disk group

An engineer is migrating an existing server node from an M1000E to a VRTX chassis. An error message appears during POST. The system will continue to boot, but can NOT see any of the chassis shared storage or PCIe devices mapped to the server slot. The engineer has already removed the original fabric interfaces in mezzanine slot B and C from the original system configuration.
Which action must the engineer complete to allow the node to see chassis storage and mapped PCIe devices?

• A.Install PCIe Pass-Through mezzanine cards
• B.Enable PCIe Pass-Through in System Setup
• C.Remap chassis storage/PCIe devices
• D.Update the CPLD firmware version

An engineer is installing 10Gb modules into a pair of MXL switches.
Which cable is correct for this installation?



D)

• A.Exhibit D
• B.Exhibit A
• C.Exhibit C
• D.Exhibit B