DCAPE-100 무료 덤프문제 온라인 액세스

A server has two 1100w power supplies. The system needs to enable or disable power supplies dynamically depending on power needs. Power Supply 2 needs to be main power supply.
Which two settings should the technician change? (Choose two.)

• A.Set Default Power Supply to PSU 2
• B.Set Primary Power Supply to PSU 2
• C.Enable Hot Spare for power supplies
• D.Enable Power Factor Correction
• E.Set Power Cap to 1100w for the system

A server arrives without any RAID configuration. All firmware is up to date. The server has a PERC H730p controller. The technician needs to configure the required RAID arrays prior to OS installation.
Which three methods can be used to configure the RAID arrays? (Choose three.)

• A.Boot into the Ctrl+R
• B.Access the Physical Disk section of the iDRAC GUI
• C.Boot into the F2 BIOS
• D.Access the Virtual Disk section of the iDRAC GUI
• E.Boot into the Ctrl+C

Refer to the exhibit.

A technician it installing an OS to a server. The OS array is 2.8TBs. The OS install is unable to start.
What should the technician do to install the OS?

• A.Switch the boot settings to UEFI
• B.Use USB to load Storage Drivers
• C.Switch the Hard Drive boot sequence so that C: is first
• D.Use LC to install the OS

A technician installs OpenManage Server Administrator (OMSA) on a server.
Which two address options should be used to access OMSA remotely using a web browser? (Choose two.)

• A.https://IP address : 443
• B.https://hostname : 2607
• C.https://IP address : 2607
• D.https://IP address : 1311
• E.https://IP address : 80
• F.https://hostname : 1311

Which three steps must a technician take prior to replacing a server component with blue tabs/release? (Choose three.)

• A.Apply anti-static procedures
• B.Hot-swap the component
• C.Powers off the server
• D.Put the server into maintenance mode
• E.Remove power cables