1Y0-A28 무료 덤프문제 온라인 액세스

Scenario: The NetScaler is configured with a NSIP of 10.20.30.40. Management access is NOT enabled on any other IP address.
Which command should an engineer execute to prevent access to the NetScaler using HTTP and only allow HTTPS access?

• A.set ip 10.20.30.40 -gui secureonly -mgmtaccess enabled
• B.set ns ip 10.20.30.40 -gui disabled -telnet disabled
• C.set ns ip 10.20.30.40 -gui enabled -restrictAccess enabled
• D.set ip 10.20.30.40 -mgmtaccess disabled -gui secureonly

How could a network engineer gather detailed network information?

• A.System node -> Diagnostics -> Show running vs saved config
• B.System node -> Diagnostics -> Call home
• C.System node -> Diagnostics -> Show techsupport
• D.System node -> Diagnostics -> Start new trace

Which two response codes and pages can be cached on the NetScaler using Integrated Caching? (Chose two.)

• A.401 Unauthorized
• B.404 Not found pages
• C.302 Found pages
• D.400 Bad request
• E.500 Internal server error

Scenario: The network engineer is setting up a new NetScaler using a direct connection. Three networks are connected to the NetScaler. After initial configuration and restart, the engineer would like to
confirm the routing table entries. From which location and which command should the engineer run to display the routing table?

• A.From the command-line interface 'show route'
• B.From the shell 'netstat -r'
• C.From the command-line interface 'show pbr'
• D.From the shell 'route monitor'

A network engineer needs to prevent too many simultaneous HTTP requests that can cause a Denial Of
Service (DDoS). What could the engineer enable to prevent too many simultaneous HTTP requests?

• A.SureConnect
• B.Rate Limiting
• C.Authorization Policy
• D.Priority Queuing