642-997 무료 덤프문제 온라인 액세스

Which two statements about SAN zoning on Cisco Nexus switches are true? (Choose two.)

• A.The settings for default zone configurations cannot be changed.
• B.Soft zoning restrictions will not prevent a source device from accessing a device outside its zone, if the source knows the Fibre Channel ID of the destination.
• C.Hard zoning is enforced by the hardware on each FLOGI sent by an N Port.
• D.To activate a zone set, you must copy the running configuration to the startup configuration after the zone set is configured.
• E.Traffic can either be permitted or denied among members of the default zone. This information is not distributed to all switches. It must be configured in each switch.
• F.Unlike configured zones, default zone information is not distributed to the other switches in the fabric.

Which FCoE component is responsible for the encapsulation and de-encapsulation of Fibre
Channel frames in Ethernet?

• A.Fibre Channel forwarder
• B.distributed FCF
• C.FCoE logical endpoint
• D.FCoE forwarder
• E.FCoE node

Refer to the exhibit.

Which statement based on these two outputs that were collected 24 hours apart is true?

• A.The MAC address that ends in 020a moved to the local site 23 hours ago.
• B.The MAC address cannot be discovered on two separate port channel interfaces.
• C.The Site 2 OTV edge device has gone down.
• D.The Overlay1 IP address should be a multicast IP address.

Which FCoE component is responsible for the encapsulation and de-encapsulation of Fibre Channel frames in Ethernet?

• A.Fibre Channel forwarder
• B.distributed FCF
• C.FCoE logical endpoint
• D.FCoE forwarder
• E.FCoE node

Which protocol is responsible for the discovery of FCoE capabilities on a remote switch?

• A.DCBx
• B.LLDP
• C.CDP
• D.DCE