642-902 무료 덤프문제 온라인 액세스

Refer to the exhibit.

A partial routing configuration is shown. Complete the configuration so that only the default
network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly?

• A.access-list 100 permit ip host 0.0.0.0 any
• B.access-list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0
• C.access-list 100 permit ip any host 0.0.0.0
• D.A default-network cannot be redistributed between routing processes.

After DUAL calculations, a router has identified a successor route, but no routes have qualified as a feasible successor. In the event that the current successor goes down, what process will EIGRP use in the selection of a new successor?

• A.The route will transition to the passive state
• B.The route will transition to the active state
• C.EIGRP will automatically use the route with the lowest feasible distance(FD)
• D.EIGRP will automatically use the route with the lowest advertised distance(AD)
• E.EIGRP will find the interface with the lowest MAC address

To configure 6to4 tunneling on a dual-stack edge router. Which three of the following are valid components in 6to4 Tunneling configuration? (Choose Three)

• A.Tunnel Keepalives
• B.Tunnel mode (6to4)
• C.IPv4 Tunnel IP address
• D.IPv4 Tunnel Destination
• E.IPv4 Tunnel Source
• F.6to4 IPv6 address (within 2002::/16)

Refer to the exhibit. EIGRP has been configured on all routers in the network. The command metric weights 0 0 1 0 0 has been added to the EIGRP process so that only the delay metric is used in the path calculations. Which router will R1 select as the successor and feasible successor for Network A?

• A.R4 becomes the successor for Network A and will be included in the routing table. No feasible successor will be selected as the advertised distance from R2 is higher than the feasible distance.
• B.R2 becomes the successor and will be placed in the routing table. No feasible successor will be selected as the reported distance from R4 is lower than the feasible distance.
• C.R2 becomes the successor and will be placed in the routing table. R4 becomes the feasible successor for Network A.
• D.R4 becomes the successor for Network A and will be placed in the routing table. R2 becomes the feasible successor for Network A.

Refer to the exhibit.

OSPF has been configured on all routers in the network. However, router R1 does not receive a default route to router R2 as intended. Which configuration change would ensure that R1 would receive a default route from R2?

• A.Add the area 1 stub command on routers R1.
• B.Add the always keyword to the default-information originate configuration command on router R2.
• C.Add the ip route 5.0.0.0 255.255.255.0 0.0.0.0 command to router R2.
• D.Remove the default information originate configuration command from router R2 and place it on router R1.