642-813 무료 덤프문제 온라인 액세스

Refer to the exhibit.

VLAN 1 and VLAN 2 are configured on the trunked links between Switch A and Switch B.
Port Fa 0/2 on Switch B is currently in a blocking state for both VLANs. What should be done to load balance VLAN traffic between Switch A and Switch B?

• A.Lower the port priority for VLAN 1 on port 0/2 for Switch A.
• B.Lower the port priority for VLAN 1 on port 0/1 for Switch
• C.Enable HSRP on the access ports.
• D.Make the bridge ID of Switch B lower than the ID of Switch A.

Refer to exhibit as:

Which statement about the EIGRP routing being performed by the switch is true?

• A.EIGRP is running normally and receiving IPv4 routing updates.
• B.The EIGRP neighbor table contains 20 neighbors.
• C.EIGRP status cannot be determined. The command show ip eigrp topology would determine the routing protocol status.
• D.The switch has not established any neighbor relationships. Further network testing and troubleshooting must be performed to determine the cause of the problem.

When you enable port security on an interface that is also configured with a voice VLAN, what is the maximum number of secure MAC addresses that should be set on the port?

• A.No value is needed if the switchport priority extend command is configured.
• B.No more than one secure MAC address should be set.
• C.No more than two secure MAC addresses should be set.
• D.The default is set.
• E.The IP phone should use a dedicated port, therefore only one MAC address is needed per port.

HOTSPOT

정답:

Explanation:
The priority value for VLAN 105 is not explicitly configured on DSW2, so it will take the default value of 100. Use the "show standby" command to verify this on DSW2.

What is needed to verify that a newly implemented security solution is performing as expected?

• A.a detailed physical and logical topology
• B.a cost analysis of the implemented solution
• C.results from audit testing of the implemented solution
• D.detailed logs from the AAA and SNMP servers