642-427 무료 덤프문제 온라인 액세스

Acme Corporation has Cisco IP Phones configured in a single-site Cisco Unified Communications Manager cluster. The 10 phones in the accounting department can call each other. Another 10
phones in the finance department can call each other. However, no phones in accounting can call the phones in finance.
Which change is needed to allow all accounting phones to call all finance phones?

• A.Ensure that all phones use SCCP signaling.
• B.Ensure that all phones are the same Cisco IP Phone model.
• C.Ensure that all accounting phones are in a CSS that contains the partition that includes the finance phones.
• D.Ensure that all finance phones are in a CSS that is in a partition that includes the accounting phones.
• E.Ensure that all phones use SIP signaling.

Refer to the SDI trace in the exhibit A PSTN call arrived at the MGCP gateway that is shown in the SDI trace.
If the caller ID that is displayed on the IP phone is 087071 222 and the HQ_clng__pty_CSS
contains the HQ_cing_pty_Pt partition, which exhibit shows the correct gateway digit manipulation"?

• A.Exhibit D
• B.Exhibit B
• C.Exhibit A
• D.Exhibit C

Which issue would cause an MGCP gateway to fail to register with Cisco Unified Communications Manager?

• A.misconfigured route group in Cisco Unified Communications Manager
• B.incorrect MGCP IP address specified in the gateway configuration in Cisco Unified Communications Manager
• C.missing the configuration command isdn bind-13 ccm-manager under the ISDN interface
• D.mismatched domain name on the MGCP gateway and Cisco Unified Communications Manager gateway configuration

Which two phones work in Cisco Unified Communications Manager Device Mobility? (Choose two.)

• A.phones with an IP address assigned using NAT/PAT
• B.phones with an IP Addressing Mode set to IPv4 Only
• C.phones with an IP address assigned by DHCP
• D.phones with an IP Addressing Mode set to IPv6 Only

Which Cisco Unified Communications Manager troubleshooting tool can be used to determine the digit manipulation path a call takes within the Cisco Unified Communications Manager system from the perspective of a specific directory number, without having the actual device at hand?

• A.Cisco Unified Syslog Viewer
• B.Cisco Unified Communications Manager Serviceability
• C.Cisco Unified Communications Manager Real Time Monitoring Tool
• D.Cisco IOS debugs
• E.Cisco Unified Communications Manager Dialed Number Analyzer