640-692 무료 덤프문제 온라인 액세스

Which statement describes the effect of the copy run start command on a router in enable mode?

• A.The router reboots and loads the last saved running configuration.
• B.A new running configuration is loaded from flash memory to the router.
• C.The running configuration of the router is saved to NVRAM and used during the boot process.
• D.A copy of the running configuration of the router is sent by FTP to a designated server.

DRAG DROP

정답:

Explanation:
The correct answer is:
Router(boot)#
Router(config-if)#
Router(config)#
Router#
Rommon>
Router>

Refer to the exhibit.

Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)

• A.Interface S0/0 on RouterB is administratively down.
• B.The encapsulation that is configured on S0/0 of RouterB does not match the encapsulation that is configured on S0/0 of RouterA.
• C.The IP address that is configured on S0/0 of RouterB is not in the correct subnet.
• D.The cable that is connected to S0/0 on RouterA is faulty.
• E.Interface S0/0 on RouterA is configured with an incorrect subnet mask.
• F.Interface S0/0 on RouterA is not receiving a clock signal from the CSU/DSU.

Refer to the exhibit.

Into which port do you insert the card?

• A.ATM
• B.Gigabit Ethernet
• C.Serial
• D.Ethernet

Which of the following best describes the cable that is used to connect a laptop to the Console port on a Cisco router?

• A.rollover
• B.crossover
• C.fiber
• D.straight-through