400-351 무료 덤프문제 온라인 액세스

You are configuring the Call Admission Control service on the wireless LAN controller. Which parameter is used to set apart how much capacity is left to be able to respond to ADDTS requests during association or re-association?

• A.Metrics Collection
• B.Expedited Bandwidth
• C.Reserved Roaming Bandwidth
• D.Maximum Retry Percent

When connecting an autonomous access point in workgroup bridge mode to a WLAN configured on a Cisco WLC. Which two options are true? (Choose two.)

• A.The WGB creates a network extension for the wired clients.
• B.The traffic of the wired client behind the WGB can be tunneled only to the Cisco WLC on the VLAN configured for the dynamic interface of the WLAN.
• C.The WGB could serve wireless clients only on the other radio not connecting to the WLAN.
• D.The WGB mode allows to connect only one wired client behind the WGB to the WLAN.
• E.The traffic of the wired client tagged on a specific VLAN behind the WGB can be tunneled to the same VLAN behind the the Cisco WLC.
• F.The WGB cannot serve wireless clients.

The IT department has completed the installation and configuration of the wireless network in their campus. They have a lot of access points and controllers to support the huge volume of WiFi devices. They have enabled load balancing, but they cannot see this function work.
Which root of the problem is true?

• A.Controllers must have the same virtual interface IP address to load balance wireless clients.
• B.Load balancing is a client decision, and some of the client devices may not support this feature.
• C.Access points must be on the same controller to load balance wireless clients.
• D.Band steering is disabled, so load balancing cannot work properly.

Refer to the exhibit after the AP mode is changed from local mode to bridge mode the AP cannot register the WLC considering the debug output into the exhibit. Which description of the issue is true?

• A.The date and time on the WLC and AP do not match
• B.DTLS is not supported in bridge mode
• C.The AP priority exceeds the number of joining APs
• D.The WLC does not have the image for the AP
• E.The AP does not have a valid certificate
• F.The AP MAC address is not added in the MAC filter list of the WLC

Which of the following are required components for Client MFP? (Choose two.)

• A.CCXv4
• B.WPA2 w/TKIP or AES-CCMP
• C.AnyConnect 3.0
• D.802.11n
• E.CCXv5