352-011 무료 덤프문제 온라인 액세스

Which network topology is characterized by a link fate-sharing situation?
A)


B)

C)

D)

• A.Exhibit C
• B.Exhibit A
• C.Exhibit B
• D.Exhibit D

Which OSPF design consideration, with regards to simplicity and address preservation, must be considered when connecting two Layer 3 switches directly using 10 GBASE-T cabling and formatting an OSPF neighbor adjacency?

• A.The OSPF Hello and Dead timers must be tuned to detect failures as quickly as possible
• B.Mesh groups must be included in the design
• C.The OSPF network type must be set to point-to-point
• D.An OSPF neighbor adjacency formed over loopback interfaces must be placed in Area 0
• E.The OSPF network type must be set to point-to-multipoint

Refer to the exhibit.

Service provider ACME Internet just added a 100 GB/s peering in Paris that it wants to use by default for outbound traffic to Big ISP. Which routing policy achieves the desired outcomes?

• A.Apply an import policy in New York that adds a Weight attribute to routes learned from Very Big ISP via Paris
• B.Use traffic engineering by injecting a preferred LOCAL_PREF attribute to routes advertised from Very Big ISP in Paris
• C.Apply an export policy in Paris by applying a MED or community attribute with a preference that very Big ISP act upon
• D.Apply an import policy hat filters longer prefixes than /24 in Brussels and zurich

At which two networks points is route summarization supported? (Choose two)

• A.At OSPF virtual-link boundaries
• B.At EIGRP stub interface boundaries
• C.At OSPF area boundaries
• D.At EIGRP interface boundaries
• E.At EIGRP AS boundaries
• F.At EIGRP are boundaries

Refer to the exhibit.

A customer currently has a large EIGRP-based network with several remote sites attached. All remote sites connect to the two corporate data centers, depicted as 10.1.1.0 and 10.1.2.0. The customer has experienced several network-wide failures where neighbors were stuck-in-active and had other network stability issues due to some links flapping. Which two redesign options increase stability and reduce the load on the remote site routers, still maintaining optimal routing between remote sites and the two data centers? (Choose two)

• A.Perform summarization at the data centers, selectively leaking routes sent to the remote sites
• B.Perform summarization at the remote sites, selectively leaking routes sent to the data centers
• C.Set the hello interval timer to be larger than the hold interval
• D.Increase the hold interval to accommodate lost hello packets on error-prone links
• E.Set the data center routers as stub-routers